Tandem Failure Data System (TFDS) Manual

Using TFDSCOM

HP Tandem Failure Data System (TFDS) Manual—540122-003

3-36

TFDSCOM Commands

Error text specifying interface problem with TFDS helper.

Error text returned from TFDS helper.

Example

STATS HELPERS

STATUS

The STATUS command returns a TFDS view of either the processors or the TFDS

helper processes. It shows the processor status and reload states.

HELPERS

requests TFDS helper process information.

Guideline

•

You can use the abbreviation s in place of STATUS

•

When HELPERS is not specified, the TFDS view of processor status is displayed.

It also shows the current reload status for each processor.

•

When HELPERS is specified, the status of all TFDS helpers currently running on

the system is returned. If incidents are being processed by a particular Helper,

information about each incident is displayed. If a Helper has tracing enabled, trace

information is also displayed.

•

The STATUS display is in this format:

is the number of seconds the reload is delayed after the RCVDUMP finishes.

is the number of consecutive halts a processor is allowed without surviving for h

hours before reloading is stifled.

STATUS [HELPERS]

TFDS current environment: @06Apr2005 08:41:31

Failures are recorded since TFDS started at dateNtime

CPU TFDS CPU CPU Time of last Time of last

No State State Dn R1 Failure Load

-- ------- ---------- -- -- ------------- -------------

c tfdsst cpust fs ft dateNtime dateNtime

AUTORELOAD [ ON [, Delay s seconds ] | OFF ]

AUTOSTIFLE [ Disabled | t Times in h Hours ]