Tandem Failure Data System (TFDS) Manual

Using TFDSCOM
HP Tandem Failure Data System (TFDS) Manual—540122-003
3-39
TFDSCOM Commands
•
The BURST SUPPRESSION task 'started' the timer (see BN command) for this
incident. (For more information, see BURSTNOTIFY on page 3-12.)
•
The BURST SUPPRESSION task detected the 'last' duplicate incident for this
symptom string.
•
The counts include
°
The number of incidents in the burst (see BN command)
°
The total number of incidents for this symptom string since this burst task
started.
•
There could be more than one entry in the list.
TFDS STOP
The TFDS STOP command lets you stop either the TFDS monitor process or one or all
of the TFDS helper processes.
HELPERS
specifies that HELPER process(es) are to be stopped, not the TFDS monitor
process.
cpu
specifies the processor in which the TFDS helper process is running. Valid values
are 0 through 15.
ALL
specifies that all TFDS helpers should be stopped.
Guidelines
•
The TFDS components should always be running.
•
Use this command instead of the TACL stop command to stop the TFDS monitor
or Helper processes. Doing so allows the TFDS processes to perform cleanup
tasks before terminating.
•
If the HELPERS option is not specified, the TFDS monitor is terminated.
•
The HELPERS option allows you to terminate the TFDS helper running on the
specified processor or all TFDS helper processes.
•
One of these messages is displayed for each TFDS helper process:
TFDS STOP [ HELPERS { cpu | ALL } ]