Tandem Failure Data System (TFDS) Manual

EMS Messages and Templates
HP Tandem Failure Data System (TFDS) Manual—540122-003
A-2
EMS Messages
EMS Messages
3
Cause. TFDS started a backup operation, but the tape unit is not ready.
Effect. The dump files cannot be saved on tape. The backup is waiting for a device.
Recovery. Mount a tape (on the tape drive specified through the TFDSCOM TAPE
command) and put the tape drive online, or issue a CANCELBACKUP command.
7
Cause. Either a dump was requested through TFDSCOM, or a Processor Down
message arrived.
Effect. A dump is started by RCVDUMP. (Dumping a processor usually takes from 5
to 20 minutes and can slow system performances during this time.) TFDS attempts to
get a successful dump and automatically reloads the processor according to your
RETRY-DUMP, RELOAD-ON-FAILURE, AUTORELOAD, and RETRY-RELOAD
configuration settings.
Recovery. Informational message only; no corrective action is needed.
9
Cause. The RCVDUMP ended successfully.
Effect. A dump file was created. Upon completion of the RCVDUMP, TFDS attempts
to reload the affected processor if the AUTORELOAD configuration setting is ON.
Recovery. Informational message only; no corrective action is needed.
10
Cause. The reload process ended successfully.
Effect. The processor is operational.
Recovery. Informational message only; no corrective action is needed.
TFDS *0003* $ZDMP : BACKUP Waiting for Device : $yyyyy
TFDS *0007* $ZDMP : DUMP; Starting a Dump for CPU : nn
TFDS *0009* $ZDMP : DUMP; Successful ReceiveDump for CPU : nn
TFDS *0010* $ZDMP : RELOAD; Successful RELOAD for CPU : nn