Tandem Failure Data System (TFDS) Manual

EMS Messages and Templates
HP Tandem Failure Data System (TFDS) Manual—540122-003
A-3
EMS Messages
13
Cause. An operator has started TFDS.
Effect. TFDS is starting up.
Recovery. Informational message only; no corrective action is needed.
16
Cause. A RCVDUMP process that TFDS started failed to finish.
Effect. A new RCVDUMP process is started. TFDS continues attempts to get a
successful dump and automatically reloads the processor according to your
RETRY-DUMP, RELOAD-ON-FAILURE, AUTORELOAD, and RETRY-RELOAD
configuration settings.
Recovery. Informational message only; no corrective action is needed.
18
Cause. The number of processor failures is greater than the number of concurrent
dumps allowed by the current TFDSCOM MAXCONDUMPS configuration setting.
Effect. A reload process is started for the specified processor. It is not dumped. If the
reload is successful, the processor is operational.
Recovery. Informational message only; no corrective action is needed.
20
Cause. An error was detected in the TFDS configuration file during TFDS initialization.
The line number and specific error are displayed.
Effect. A default value is assigned to the configuration option not properly specified.
Recovery. Use the TFDSCOM CONFIG command to view the TFDS configuration file,
and use TFDSCOM commands to edit the TFDS configuration file as needed.
TFDS *0013* $ZDMP : TFDS Starting in CPU : nn
TFDS *0016* $ZDMP: RCVDUMP of CPU nn Failed. Attempting Retry
Number: nn
TFDS *0018* $ZDMP: Too many concurrent CPU dumps.
Reloading CPU: nn
TFDS *0020* Configuration Error: xxxxxxxx