TMF Management Programming Manual (H06.05+)

Commands and Responses
HP NonStop TMF Management Programming Manual—540140-002
5-88
ENABLE DATAVOLS
ENABLE DATAVOLS
The ENABLE DATAVOLS command reenables transaction processing (audited
updates) for the specified data volumes, and makes them subject to automatic restart
by TMF. If the data volumes specified are accessible, they are restarted immediately.
Command Syntax
Refer to the SPI Programming Manual for tokens present in the command and
response buffers but not described below.
Tokens in Command Buffer
ZTMF-TKN-VolumeName
specifies the name of a disabled disk volume for which transaction processing is to
be reenabled. This token must occur at least once; multiple occurrences are
allowed.
ZTMF-TKN-VolumeName can also contain a wild card (value “*”, length 1). If the
wild card is specified, it must be the only instance of this token in the command
buffer. The wild card specifies that all disabled data volumes in the TMF
configuration are to be reenabled; exceptions are the volumes specified in the
ZTMF-TKN-NotVolumeName token, if any.
Command
ZTMF-CMD-Enable
Object Type
ZTMF-OBJ-DataVols
Tokens in Command Buffer
ZTMF-TKN-VolumeName token-type ZSPI-TYP-String.
ZTMF-TKN-NotVolumeName token-type ZSPI-TYP-String.
ZSPI-TKN-MaxResp token-type ZSPI-TYP-Int.
ZSPI-TKN-Context token-type ZSPI-TYP-ByteString.
Tokens in Response Buffer
ZTMF-TKN-VolumeName token-type ZSPI-TYP-String.
ZSPI-TKN-Context token-type ZSPI-TYP-ByteString.