TMF Management Programming Manual (H06.05+)

Commands and Responses
HP NonStop TMF Management Programming Manual—540140-002
5-142
RELOCATE DISKDUMPS
ZTMF-ERR-InvalidDumpSerial
The command failed because the value specified for DumpSerial was neither
the wild value nor a value higher than 63.
ZTMF-ERR-OnlyOneOldDmLoc
The command failed because there was more than one occurrence of the
ZTMF-TKN-OldDMLoc token in the input buffer.
ZTMF-ERR-OnlyOneNewDmLoc
The command failed because there was more than one occurrence of the
ZTMF-TKN-NewDmLoc token in the input buffer.
ZTMF-ERR-WarnNoDumpsRelocated
No dumps were relocated because, for example, a specified dump serial
number or the specified OldDmLoc does not exist.
ZTMF-TKN-DumpSerial
specifies the invalid dump serial number that caused the RELOCATE DISKDUMPS
command to fail.
ZTMF-TKN-OldDmLoc
specifies the invalid old disk media location that caused the RELOCATE
DISKDUMPS command to fail.
ZTMF-TKN-NewDmLoc
specifies the invalid new disk media location that caused the RELOCATE
DISKDUMPS command to fail.
Usage Guidelines
Only super-group users can issue this command. TMF must be started before you
issue the RELOCATE DISKDUMPS command.
If a wild card (*) is specified for ZTMF-TKN-OldDmLoc, a wild card must also be used
for ZTMF-TKN-NewDmLoc.
For more information about the RELOCATE DISKDUMPS command, see the TMF
Reference Manual.