TMF Management Programming Manual (H06.05+)
Commands and Responses
HP NonStop TMF Management Programming Manual—540140-002
5-147
START TMF
•
The START TMF command fails if one of the following conditions occur:
•
The master audit trail is not configured.
•
A wild card audit trail is not configured.
•
An audit trail has not been defined for a disk process.
•
An audit trail requires an audit dump process that has not been configured. An
audit dump process is configured but is not required by any audit trail.
•
An audit dump process is configured but labeled-tape support for the NonStop
OS is not enabled.
•
A previous START TMF command has already been issued.
•
A STOP TMF command is in progress.
•
A failure has occurred that requires the system to be cold-loaded before TMF
can be restarted.