TMF Management Programming Manual (H06.05+)

Commands and Responses
HP NonStop TMF Management Programming Manual—540140-002
5-149
STATUS ATFILE
Tokens in Command Buffer
ZTMF-TKN-AuditTrailId
specifies an audit trail for which status information about all of its files is to be
returned. This token is required; only one occurrence is allowed. The following
values are valid:
The value ZTMF-VAL-WildAuditTrailId is not valid in this command.
ZTMF-TKN-ATFileStatus
specifies the file status used to select which audit-trail files are to be returned. This
token is optional; multiple occurrences are allowed.
If multiple status values are specified, information is returned on all files that meet
any of the specified status values (that is, the values are logically “or-ed”). If you
omit this token, then information is returned on all files.
This token is used with ZTMF-TKN-ATFileDumpStatus. Information is returned
only on files that meet the selection criteria specified in both tokens (that is, the two
tokens are logically “and-ed”).
The following values are valid:
ZTMF-VAL-ATFileActive
specifies active files. These files include the current file (and files that precede
the current file) and those that contain any audit trail needed by TMF for active
transactions—or for potential use in volume recovery (or system restart).
It is possible to have a single active file beyond the current file. This occurs
when the current file is almost full and TMF has prepared the next file for a
rollover.
ZTMF-VAL-ATFileAvailable
specifies available files. These files are no longer needed for active
transactions, volume recovery, or system restart. A file is available for reuse
when the current file becomes full. These files remain intact until needed—a
file recovery operation might need them.
ZTMF-VAL-Mat Master audit trail
ZTMF-VAL-Aux01 Auxiliary audit trail #1
ZTMF-VAL-Aux02 Auxiliary audit trail #2
. . .
ZTMF-VAL-Aux015 Auxiliary audit trail #15