TMF Management Programming Manual (H06.05+)

Commands and Responses
HP NonStop TMF Management Programming Manual—540140-002
5-168
STATUS DATAVOLS
ZTMF-VAL-DVS-AwaitTransResolve
specifies configured data volumes that are being restarted, where the
restart is waiting for the resolution of transactions that may have modified
data on the volume. The subsystem must be notified of the outcome
(commit or abort) of these transactions before these volumes can take part
in recovery. A data volume can linger in this state if lengthy transactions
exist in the system or if the outcome of a distributed transaction cannot be
determined.
ZTMF-VAL-DVS-QueuedForRecovery
specifies configured volumes that are ready for volume recovery but are
waiting for process availability. A data volume remains in this state until it
is assigned to a volume-recovery process. The data volume might have to
wait for an existing volume recovery to complete.
ZTMF-VAL-DVS-Recovering
specifies configured volumes that are being operated on by a volume-
recovery process.
ZTMF-VAL-DVS-StartupCompleting
specifies configured volumes for which startup is nearly complete. The
associated disk process is processing the final startup request. Typically, a
data volume remains in this state only very briefly.
ZTMF-VAL-DVS-Started
specifies configured volumes that are ready to process TMF transactions.
Audited requests are allowed only for data volumes in this state as long as
transaction processing is enabled within the subsystem.
ZTMF-VAL-DVS-NotStarted
specifies configured volumes that are not in the started state.
ZTMF-VAL-DVS-Down
specifies configured volumes that are in either the down-clean or down-
dirty state.
ZTMF-VAL-DVS-Down-Clean
specifies configured volumes that are inaccessible, perhaps because of
device or process problems, and on which no updates have been made to
audited files since the volume last underwent a clean shutdown. Audited
files on volumes in this state do not contain any inconsistencies.