TMF Management Programming Manual (H06.05+)

Error and Warning Messages
HP NonStop TMF Management Programming Manual—540140-002
7-62
Archive Tape Errors and Warnings
8122 Tape parity error(s) and/or tape record checksum error(s) occurred
on the beginning volume labels. Error recovery was able to
recognize the tape.
Parity or checksum errors occurred on some of the beginning volume labels.
Such errors might be caused by the beginning of the tape being worn out, or to
dirty tape drive heads.
8123 An EOF mark was found where begin volume labels were expected.
The tape format is invalid.
8124 Tape parity error(s) and/or tape record checksum error(s) occurred
on the beginning volume labels. Error recovery was able to
recognize the tape.
A tape specified by the TMF catalog was not from the same tape set as the
previous tape(s). This could have been caused by an erroneous ADD DUMPS
command.
8125 Wrong tape mounted (Found tape # ZART-TKN-TAPENUM, expected
tape #ZART-TKN-EXPECTEDTAPENUM). The TMF Catalog has
incorrect information.
A tape specified by the TMF catalog was the wrong tape within the tape set.
This could have been caused by an erroneous ADD DUMPS command.
8150 The data read from both parallel copies did not match.
The data records read from each parallel copy during tape verification were not
equal. The checksums and tape sequence numbers for each record were
correct, yet the data was not the same.
8151 Premature end of tape.
The end of tape marker is very close to the beginning of tape marker, or the
tape drive is faulty.
8154 During repositioning an EOF mark was not found where it was
expected.
While a dump process was repositioning the tape to overwrite an aborted file, an
EOF mark was not found where it was expected.
8155 During repositioning an EOF mark was found where a record was
expected.
While a dump process was repositioning the tape to overwrite an aborted file, an
EOF mark was found where a record was expected.