TMF Management Programming Manual (H06.05+)

Commands and Responses
HP NonStop TMF Management Programming Manual—540140-002
5-19
ADD DUMPS
ZDataSequence
specifies the auxiliary audit trail sequence number that was active when the
dump was made. This field is required if the value of ZDumpType is
ZTMF-VAL-OnlineDump.
ZMedium
specifies the type of storage media used to make this dump. This field is
required. The following values are valid:
ZTimeStamp
specifies the time when the audit dump was recorded. If null, the default is the
current TMFSERVE time—that is, the current time is recorded into the catalog
that has the audit dump being added.
Usage Guidelines
Only super-group users can issue this command.
For more information about the ADD DUMPS command, see the TMF Reference
Manual.
Note. If only a master audit trail is configured, the values for ZMasterSequence and
ZDataSequence are identical.
ZTMF-VAL-MediumTape Tape storage media
ZTMF-VAL-MediumMagneticDisk Magnetic disk storage media
Caution. If recovery is needed, problems can occur if the time listed in the catalog is not the
time when the dump actually took place. If you specify a value for ZTimeStamp, make sure to
enter the date and time completely and accurately.