TMF Management Programming Manual (H06.05+)

Commands and Responses
HP NonStop TMF Management Programming Manual—540140-002
5-22
ADD MEDIA
ZTMF-VAL-Scratch
specifies that the tape volume can be used for dumping files.
ZDensity
specifies the density at which the tapes are written. This field is only valid if
ZLabelMedia is ZSPI-VAL-True. The following values are valid:
ZTapeMode
specifies the kind of write operation performed by the tape drive and is
applicable only for streaming tape drives. This field is only valid if ZLabelMedia
is ZSPI-VAL-True. The following values are valid:
ZTMF-VAL-StartStop
ZTMF-VAL-Stream
ZTMF-VAL-StreamSlow
ZTMF-VAL-StreamFast
If this field is null, the default value depends upon the tape drive. You can
specify either ZDensity or ZTapeMode, but not both in the same command.
ZTapeDrive
specifies the name of the tape drive on which you want to label tape volumes.
Guardian labeled-tape processing must be enabled on the node (system) you
specify. This field is required if the value of ZLabelMedia is ZSPI-VAL-True.
ZOperatorDevice
specifies the name of the device on which TAPECOM prompts are to be
displayed. This field is required if the value of ZLabelMedia is ZSPI-VAL-True.
Usage Guidelines
Only super-group users can issue this command.
For more information about the ADD TAPEMEDIA command, see the TMF Reference
Manual.
ZTMF-VAL-Default If this field is null, the default value depends
upon the tape drive.
ZTMF-VAL-800BPI The density is 800 bits per inch.
ZTMF-VAL-1600BPI The density is 1600 bits per inch.
ZTMF-VAL-6250BPI The density is 6250 bits per inch.