TMF Management Programming Manual (H06.05+)

Commands and Responses
HP NonStop TMF Management Programming Manual—540140-002
5-27
ALTER AUDITDUMP
Tokens in Command Buffer
ZTMF-TKN-AuditTrailId
specifies the audit trail associated with the audit dump process whose attributes
are to be altered. This token is required; only one occurrence is allowed. The
following values are valid:
ZTMF-TKN-AddDiskMedia
specifies disk volumes to be added to the audit dump process configuration. This
token is only valid if ZMedium is ZTMF-VAL-MediumMagneticDisk.
This token can occur from zero to 16 times; however there is a maximum of 16
disk media attributes that can be configured for the process. If the limit is
exceeded, the ZTMF-ERR-TooManyDiskMedia error is returned and the command
fails. If the disk media to be added already exists in the configuration, the ZTMF-
ERR-DiskMediaExists error is returned.
If you specify multiple disk volumes, the subsystem tries to send the audit dump to
the first disk listed. If that disk cannot be accessed or is out of space, the
subsystem tries the next disk, and so forth.
If you specify a disk that does not exist, the subsystem does not report this error at
once; however, it does report the error when the next dump actually takes place.
ZTMF-TKN-DelDiskMedia
specifies disk volumes to be deleted from the audit dump process configuration.
This token is only valid if ZMedium is ZTMF-VAL-MediumMagneticDisk.
This token can occur from zero to 16 times. If the disk media does not currently
exist in the configuration, the ZTMF-ERR-DiskMediaNotFound message is
returned.
ZTMF-VAL-Mat Master audit trail
ZTMF-VAL-Aux01 Auxiliary audit trail #1
ZTMF-VAL-Aux02 Auxiliary audit trail #2
. . .
ZTMF-VAL-Aux015 Auxiliary audit trail #15