TMF Management Programming Manual (H06.06+, J06.03+)
Table Of Contents
- HP NonStop TMF Management Programming Manual
- Legal Notices
- Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction to TMF
- 2 Communicating With the TMFSERVE Process
- 3 SPI Programming Considerations for TMF
- 4 Common Definitions
- 5 Commands and Responses
- Command Summary
- Command Descriptions
- ABORT TRANSACTION
- ADD AUDITTRAIL
- ADD DATAVOLS
- ADD DUMPS
- ADD MEDIA
- ADD RESOURCEMANAGER
- ALTER AUDITDUMP
- ALTER AUDITTRAIL
- ALTER BEGINTRANS
- ALTER CATALOG
- ALTER DATAVOLS
- ALTER DUMPS
- ALTER MEDIA
- ALTER PROCESS
- ALTER TMF
- CANCEL OPERATION
- CLOSE RESOURCEMANAGER
- DELETE CATALOG
- DELETE DATAVOLS
- DELETE DUMPS
- DELETE MEDIA
- DELETE RESOURCEMANAGER
- DELETE TMF
- DELETE TRANSACTION
- DISABLE AUDITDUMP
- DISABLE BEGINTRANS
- DISABLE DATAVOLS
- DUMP FILES
- ENABLE AUDITDUMP
- ENABLE BEGINTRANS
- ENABLE DATAVOLS
- INFO ATDUMPDM
- INFO ATVOLUME
- INFO AUDITDUMP
- INFO AUDITTRAIL
- INFO BEGINTRANS
- INFO CATALOG
- INFO DATAVOLS
- INFO DUMPS
- INFO MEDIA
- INFO PROCESS
- INFO RESOURCEMANAGER
- INFO TMF
- LIST AUDITTRAIL
- NEXT AUDITTRAIL
- RECOVER FILES
- RELOCATE DISKDUMPS
- RESOLVE TRANSACTION
- START TMF
- STATUS ATFILE
- STATUS AUDITDUMP
- STATUS AUDITTRAIL
- STATUS BEGINTRANS
- STATUS CATALOG
- STATUS DATAVOLS
- STATUS OPERATION
- STATUS RESOURCEMANAGER
- STATUS RMTRANSBRANCHES
- STATUS TMF
- STATUS TMFSERVER
- STATUS TRANSACTION
- STATUS TRANSACTIONCHILDREN
- STOP TMF
- 6 Event Messages
- 7 Error and Warning Messages
- A TMF Configuration Limits and Defaults
- Index
Commands and Responses
HP NonStop TMF Management Programming Manual—540140-010
5-103
INFO AUDITTRAIL
ZAuditDump
specifies whether audit dumping is performed for the audit trail. The following
values are possible:
ZOverflowThreshold
specifies the percentage of active audit-trail capacity above which TMF begins
overflow copying.
ZBeginTransDisable
specifies the percentage of active audit-trail capacity that can be consumed
before new transactions are disabled.
ZMaxRetainedATFiles
specifies the maximum number of restored audit-trail files to retain on disk in
the RestoreVols for the specified audit trail after the restored audit-trail files are
no longer being used by a recovery process. The minimum value is 0, the
maximum 9999.
ZFileSize32
specifies the size of the audit-trail file, in megabytes. For the RVU covered by
this manual and all subsequent RVUs, ZFileSize32 always contains the correct
audit-trail file size.
ZCommitHoldMode
specifies the current state of the commit-hold attribute for the specified audit
trail. The following values are valid:
ZSPI-VAL-True Audit dumping is performed
ZSPI-VAL-False Audit dumping is not performed
ZTMF-VAL-ZLTCH-UnSupported Commit-hold mode is not
supported by the specified audit
trail.
ZTMF-VAL-ZLTCH-UnConfigured Commit-hold mode is not yet
configured for the specified audit
trail.
ZTMF-VAL-ZLTCH-On Commit-hold mode is on for the
specified audit trail.
ZTMF-VAL-ZLTCH-Off Commit-hold mode is off for the
specified audit trail.