TMF Management Programming Manual (H06.06+, J06.03+)
Table Of Contents
- HP NonStop TMF Management Programming Manual
- Legal Notices
- Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction to TMF
- 2 Communicating With the TMFSERVE Process
- 3 SPI Programming Considerations for TMF
- 4 Common Definitions
- 5 Commands and Responses
- Command Summary
- Command Descriptions
- ABORT TRANSACTION
- ADD AUDITTRAIL
- ADD DATAVOLS
- ADD DUMPS
- ADD MEDIA
- ADD RESOURCEMANAGER
- ALTER AUDITDUMP
- ALTER AUDITTRAIL
- ALTER BEGINTRANS
- ALTER CATALOG
- ALTER DATAVOLS
- ALTER DUMPS
- ALTER MEDIA
- ALTER PROCESS
- ALTER TMF
- CANCEL OPERATION
- CLOSE RESOURCEMANAGER
- DELETE CATALOG
- DELETE DATAVOLS
- DELETE DUMPS
- DELETE MEDIA
- DELETE RESOURCEMANAGER
- DELETE TMF
- DELETE TRANSACTION
- DISABLE AUDITDUMP
- DISABLE BEGINTRANS
- DISABLE DATAVOLS
- DUMP FILES
- ENABLE AUDITDUMP
- ENABLE BEGINTRANS
- ENABLE DATAVOLS
- INFO ATDUMPDM
- INFO ATVOLUME
- INFO AUDITDUMP
- INFO AUDITTRAIL
- INFO BEGINTRANS
- INFO CATALOG
- INFO DATAVOLS
- INFO DUMPS
- INFO MEDIA
- INFO PROCESS
- INFO RESOURCEMANAGER
- INFO TMF
- LIST AUDITTRAIL
- NEXT AUDITTRAIL
- RECOVER FILES
- RELOCATE DISKDUMPS
- RESOLVE TRANSACTION
- START TMF
- STATUS ATFILE
- STATUS AUDITDUMP
- STATUS AUDITTRAIL
- STATUS BEGINTRANS
- STATUS CATALOG
- STATUS DATAVOLS
- STATUS OPERATION
- STATUS RESOURCEMANAGER
- STATUS RMTRANSBRANCHES
- STATUS TMF
- STATUS TMFSERVER
- STATUS TRANSACTION
- STATUS TRANSACTIONCHILDREN
- STOP TMF
- 6 Event Messages
- 7 Error and Warning Messages
- A TMF Configuration Limits and Defaults
- Index
Commands and Responses
HP NonStop TMF Management Programming Manual—540140-010
5-118
INFO DUMPS
ZMasterSequence
ZDataSequence
are not valid for command buffers.
ZDumpStatus
specifies the dump status to search for. The following values are valid:
If you omit this field, the default is all three.
ZMediaStatus
This field is not valid for command buffers.
ZSortSelect
specifies the order in which the dump entries are to be returned. The following
values are valid:
If you omit this field, the default is ZTMF-VAL-ByName.
ZTimeStamp
ZSystemNumber
ZMedia
are not valid for command buffers.
ZMedium
specifies the type of storage medium to search for. The following values are
valid:
If you omit this field, the default is both.
ZDiskMedia
This field is not valid for command buffers.
ZTMF-VAL-Assigned The tape volume contains valid dumps
ZTMF-VAL-Released The contents of the tape volume is not required
for file recovery
ZTMF-VAL-Invalid The tape volume cannot be used for file
recovery
ZTMF-VAL-BySerial The selected dumps are returned in descending
numeric order by serial number
ZTMF-VAL-ByName The selected dumps are returned alphabetically
by file name
ZTMF-VAL-MediumTape Tape storage media
ZTMF-VAL-MediumMagneticDisk Magnetic disk storage media