TMF Management Programming Manual (H06.06+, J06.03+)
Table Of Contents
- HP NonStop TMF Management Programming Manual
- Legal Notices
- Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction to TMF
- 2 Communicating With the TMFSERVE Process
- 3 SPI Programming Considerations for TMF
- 4 Common Definitions
- 5 Commands and Responses
- Command Summary
- Command Descriptions
- ABORT TRANSACTION
- ADD AUDITTRAIL
- ADD DATAVOLS
- ADD DUMPS
- ADD MEDIA
- ADD RESOURCEMANAGER
- ALTER AUDITDUMP
- ALTER AUDITTRAIL
- ALTER BEGINTRANS
- ALTER CATALOG
- ALTER DATAVOLS
- ALTER DUMPS
- ALTER MEDIA
- ALTER PROCESS
- ALTER TMF
- CANCEL OPERATION
- CLOSE RESOURCEMANAGER
- DELETE CATALOG
- DELETE DATAVOLS
- DELETE DUMPS
- DELETE MEDIA
- DELETE RESOURCEMANAGER
- DELETE TMF
- DELETE TRANSACTION
- DISABLE AUDITDUMP
- DISABLE BEGINTRANS
- DISABLE DATAVOLS
- DUMP FILES
- ENABLE AUDITDUMP
- ENABLE BEGINTRANS
- ENABLE DATAVOLS
- INFO ATDUMPDM
- INFO ATVOLUME
- INFO AUDITDUMP
- INFO AUDITTRAIL
- INFO BEGINTRANS
- INFO CATALOG
- INFO DATAVOLS
- INFO DUMPS
- INFO MEDIA
- INFO PROCESS
- INFO RESOURCEMANAGER
- INFO TMF
- LIST AUDITTRAIL
- NEXT AUDITTRAIL
- RECOVER FILES
- RELOCATE DISKDUMPS
- RESOLVE TRANSACTION
- START TMF
- STATUS ATFILE
- STATUS AUDITDUMP
- STATUS AUDITTRAIL
- STATUS BEGINTRANS
- STATUS CATALOG
- STATUS DATAVOLS
- STATUS OPERATION
- STATUS RESOURCEMANAGER
- STATUS RMTRANSBRANCHES
- STATUS TMF
- STATUS TMFSERVER
- STATUS TRANSACTION
- STATUS TRANSACTIONCHILDREN
- STOP TMF
- 6 Event Messages
- 7 Error and Warning Messages
- A TMF Configuration Limits and Defaults
- Index
Commands and Responses
HP NonStop TMF Management Programming Manual—540140-010
5-165
STATUS AUDITTRAIL
ZCommitHoldTime
This value is valid only when ZCommitHold is “activate” or “reviving.” The value
specifies the time at which the specified audit trail went into its current state.
ZCommitHoldVol
This value is valid only when ZCommitHold is “activate” or “reviving.” The value
specifies the name of the audit-trail volume that encountered the problem
causing the audit trail to go into this state.
ZCommitHoldTimeRem
If the specified audit trail's ZCommitHold state is either “activate” or “reviving,”
and the MAT's commit-hold mode has not been altered to “suspend,” the value
of this token is the time in seconds before the MAT's ON TIMEOUT action will
occur. If the MAT's TIMEOUT is -1, the value of this token is null.
ZTimeoutAction
The action that will occur when the ZCommitHoldTimeRem expires. This action
is the MAT's ON TIMEOUT action. The following values are possible:
Usage Guidelines
Any user can issue this command. TMF must be started.
Multiple response records are allowed to enable the command to return all the
requested information.
ZTMF-VAL-ZLTCH-ActionSuspend Suspend the commit-hold
condition.
ZTMF-VAL-ZLTCH-ActionCrash Crash TMF.