TMF Management Programming Manual (H06.06+, J06.03+)
Table Of Contents
- HP NonStop TMF Management Programming Manual
- Legal Notices
- Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction to TMF
- 2 Communicating With the TMFSERVE Process
- 3 SPI Programming Considerations for TMF
- 4 Common Definitions
- 5 Commands and Responses
- Command Summary
- Command Descriptions
- ABORT TRANSACTION
- ADD AUDITTRAIL
- ADD DATAVOLS
- ADD DUMPS
- ADD MEDIA
- ADD RESOURCEMANAGER
- ALTER AUDITDUMP
- ALTER AUDITTRAIL
- ALTER BEGINTRANS
- ALTER CATALOG
- ALTER DATAVOLS
- ALTER DUMPS
- ALTER MEDIA
- ALTER PROCESS
- ALTER TMF
- CANCEL OPERATION
- CLOSE RESOURCEMANAGER
- DELETE CATALOG
- DELETE DATAVOLS
- DELETE DUMPS
- DELETE MEDIA
- DELETE RESOURCEMANAGER
- DELETE TMF
- DELETE TRANSACTION
- DISABLE AUDITDUMP
- DISABLE BEGINTRANS
- DISABLE DATAVOLS
- DUMP FILES
- ENABLE AUDITDUMP
- ENABLE BEGINTRANS
- ENABLE DATAVOLS
- INFO ATDUMPDM
- INFO ATVOLUME
- INFO AUDITDUMP
- INFO AUDITTRAIL
- INFO BEGINTRANS
- INFO CATALOG
- INFO DATAVOLS
- INFO DUMPS
- INFO MEDIA
- INFO PROCESS
- INFO RESOURCEMANAGER
- INFO TMF
- LIST AUDITTRAIL
- NEXT AUDITTRAIL
- RECOVER FILES
- RELOCATE DISKDUMPS
- RESOLVE TRANSACTION
- START TMF
- STATUS ATFILE
- STATUS AUDITDUMP
- STATUS AUDITTRAIL
- STATUS BEGINTRANS
- STATUS CATALOG
- STATUS DATAVOLS
- STATUS OPERATION
- STATUS RESOURCEMANAGER
- STATUS RMTRANSBRANCHES
- STATUS TMF
- STATUS TMFSERVER
- STATUS TRANSACTION
- STATUS TRANSACTIONCHILDREN
- STOP TMF
- 6 Event Messages
- 7 Error and Warning Messages
- A TMF Configuration Limits and Defaults
- Index
Commands and Responses
HP NonStop TMF Management Programming Manual—540140-010
5-167
STATUS BEGINTRANS
Tokens in Response Buffer
ZTMF-MAP-Status-BeginTrans
is an extensible structured token describing why BEGINTRANSACTION is
currently disabled. This token appears once in each response record. This token
contains the following fields:
ZDisableCount
specifies the number of reasons BEGINTRANSACTION is currently disabled. If
this value is 0, BEGINTRANSACTION is enabled.
ZDisableTxCount
specifies whether BEGINTRANSACTION is disabled because the current
number of transactions in the system exceeds the configured transaction count
threshold. The following values are possible:
ZDisableOper
specifies whether BEGINTRANSACTION is disabled by a DISABLE
BEGINTRANS command. The following values are possible:
ZDisableStop
specifies whether BEGINTRANSACTION is disabled because TMF is not fully
started. The following values are possible:
ZDisableAt
is an array of Booleans that can occur 16 times. The i
th
element of the array
specifies whether BEGINTRANSACTION is disabled because the audit trail
reached its BEGINTRANSDISABLE threshold. The following values are
possible:
ZSPI-VAL-True The reason for the disable is true.
ZSPI-VAL-False The reason for the disable is false.
ZSPI-VAL-True The reason for the disable is true.
ZSPI-VAL-False The reason for the disable is false.
ZSPI-VAL-True The reason for the disable is true.
ZSPI-VAL-False The reason for the disable is false.
ZSPI-VAL-True The reason for the disable is true.
ZSPI-VAL-False The reason for the disable is false.