TMF Management Programming Manual (H06.06+, J06.03+)
Table Of Contents
- HP NonStop TMF Management Programming Manual
- Legal Notices
- Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction to TMF
- 2 Communicating With the TMFSERVE Process
- 3 SPI Programming Considerations for TMF
- 4 Common Definitions
- 5 Commands and Responses
- Command Summary
- Command Descriptions
- ABORT TRANSACTION
- ADD AUDITTRAIL
- ADD DATAVOLS
- ADD DUMPS
- ADD MEDIA
- ADD RESOURCEMANAGER
- ALTER AUDITDUMP
- ALTER AUDITTRAIL
- ALTER BEGINTRANS
- ALTER CATALOG
- ALTER DATAVOLS
- ALTER DUMPS
- ALTER MEDIA
- ALTER PROCESS
- ALTER TMF
- CANCEL OPERATION
- CLOSE RESOURCEMANAGER
- DELETE CATALOG
- DELETE DATAVOLS
- DELETE DUMPS
- DELETE MEDIA
- DELETE RESOURCEMANAGER
- DELETE TMF
- DELETE TRANSACTION
- DISABLE AUDITDUMP
- DISABLE BEGINTRANS
- DISABLE DATAVOLS
- DUMP FILES
- ENABLE AUDITDUMP
- ENABLE BEGINTRANS
- ENABLE DATAVOLS
- INFO ATDUMPDM
- INFO ATVOLUME
- INFO AUDITDUMP
- INFO AUDITTRAIL
- INFO BEGINTRANS
- INFO CATALOG
- INFO DATAVOLS
- INFO DUMPS
- INFO MEDIA
- INFO PROCESS
- INFO RESOURCEMANAGER
- INFO TMF
- LIST AUDITTRAIL
- NEXT AUDITTRAIL
- RECOVER FILES
- RELOCATE DISKDUMPS
- RESOLVE TRANSACTION
- START TMF
- STATUS ATFILE
- STATUS AUDITDUMP
- STATUS AUDITTRAIL
- STATUS BEGINTRANS
- STATUS CATALOG
- STATUS DATAVOLS
- STATUS OPERATION
- STATUS RESOURCEMANAGER
- STATUS RMTRANSBRANCHES
- STATUS TMF
- STATUS TMFSERVER
- STATUS TRANSACTION
- STATUS TRANSACTIONCHILDREN
- STOP TMF
- 6 Event Messages
- 7 Error and Warning Messages
- A TMF Configuration Limits and Defaults
- Index
Commands and Responses
HP NonStop TMF Management Programming Manual—540140-010
5-191
STATUS TMF
Tokens in Response Buffer
ZTMF-MAP-Status-Tmf
is an extensible structured token containing the status information for TMF. This
token contains the following fields:
ZSystemName
specifies the local system name.
ZSystemNumber
specifies the number of the local system.
ZSystemTime
specifies the local system time (GMT).
ZTmfState
specifies the state of TMF. The following values are possible:
ZTMF-VAL-TmfState-EmptyATCnfg
TMF has been brought up for the first time on this node and thus no
configuration exists for it, or a DELETE TMF command was performed.
(You must add at least one audit trail (by using the ADD AUDITTRAIL
command) to start TMF.)
ZTMF-VAL-TmfState-ConfigAT
TMF has not been started using this configuration. It is still possible to add
additional audit trails by using the ADD AUDITTRAIL command, or alter
previously added audit trails by using the ALTER AUDITTRAIL command.
ZTMF-VAL-TmfState-Stopped
TMF is stopped.
ZTMF-VAL-TmfState-Starting
TMF is starting and is in one of the conditions indicated by
ZStartingSTATE.
ZTMF-VAL-TmfState-Started
TMF is started.
ZTMF-VAL-TmfState-Stopping
TMF is stopping and is in one of the conditions indicated by
ZStoppingState.