TMF Management Programming Manual (H06.06+, J06.03+)
Table Of Contents
- HP NonStop TMF Management Programming Manual
- Legal Notices
- Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction to TMF
- 2 Communicating With the TMFSERVE Process
- 3 SPI Programming Considerations for TMF
- 4 Common Definitions
- 5 Commands and Responses
- Command Summary
- Command Descriptions
- ABORT TRANSACTION
- ADD AUDITTRAIL
- ADD DATAVOLS
- ADD DUMPS
- ADD MEDIA
- ADD RESOURCEMANAGER
- ALTER AUDITDUMP
- ALTER AUDITTRAIL
- ALTER BEGINTRANS
- ALTER CATALOG
- ALTER DATAVOLS
- ALTER DUMPS
- ALTER MEDIA
- ALTER PROCESS
- ALTER TMF
- CANCEL OPERATION
- CLOSE RESOURCEMANAGER
- DELETE CATALOG
- DELETE DATAVOLS
- DELETE DUMPS
- DELETE MEDIA
- DELETE RESOURCEMANAGER
- DELETE TMF
- DELETE TRANSACTION
- DISABLE AUDITDUMP
- DISABLE BEGINTRANS
- DISABLE DATAVOLS
- DUMP FILES
- ENABLE AUDITDUMP
- ENABLE BEGINTRANS
- ENABLE DATAVOLS
- INFO ATDUMPDM
- INFO ATVOLUME
- INFO AUDITDUMP
- INFO AUDITTRAIL
- INFO BEGINTRANS
- INFO CATALOG
- INFO DATAVOLS
- INFO DUMPS
- INFO MEDIA
- INFO PROCESS
- INFO RESOURCEMANAGER
- INFO TMF
- LIST AUDITTRAIL
- NEXT AUDITTRAIL
- RECOVER FILES
- RELOCATE DISKDUMPS
- RESOLVE TRANSACTION
- START TMF
- STATUS ATFILE
- STATUS AUDITDUMP
- STATUS AUDITTRAIL
- STATUS BEGINTRANS
- STATUS CATALOG
- STATUS DATAVOLS
- STATUS OPERATION
- STATUS RESOURCEMANAGER
- STATUS RMTRANSBRANCHES
- STATUS TMF
- STATUS TMFSERVER
- STATUS TRANSACTION
- STATUS TRANSACTIONCHILDREN
- STOP TMF
- 6 Event Messages
- 7 Error and Warning Messages
- A TMF Configuration Limits and Defaults
- Index
Event Messages
HP NonStop TMF Management Programming Manual—540140-010
6-16
Recovery Event Messages
331 Rcov-ExtSeg-Too-Small A TMF recovery process, usually backout,
has insufficient extended memory to perform
the required recovery
350 FRlist-ErrFromTmp File-system error returned by TMP while
attempting to retrieve volume information
351 FRlist-ErrFromDataVol File-system error returned while attempting
to retrieve file-related information
352 FRlist-NoCatalogEntry FROMARCHIVE option specified, but no
entry was found in TMF Catalog for the
specified table or file
353 FRlist-FileNotFound Table or file could not be found on the
specified data volume
354 FRlist-LogicalNotUndo FROMARCHIVE option not specified. Table
or file should have UNDONEEDED flag set,
but does not
355 Rcov-FsError4 File-system error encountered during volume
or file recovery
356 Rcov-FsError5 File-system error encountered during volume
or file recovery
357 Rcov-FsError6 File-system error encountered during volume
or file recovery
358 Rcov-StopObjectRcov2 Recovery terminated
359 Rcov-EndAtFileHiatus2 File hiatus record encountered in database
table or file during recovery
400 FRToMatPosition TOMATPOSITION option of the RECOVER
FILES command is being used
401 FRRedoPassComplete File recovery or volume recovery has
completed the redo pass
402 FRFilTrnsPassComplete File recovery or volume recovery has
completed the build file transaction pass
403 FRUndoPassComplete File recovery or volume recovery has
completed the undo pass
434 Rcov-NoNodeNameInAt Describes a problem in the audit trails that
are being used to recover files when the
SETDRMODE flag has been set on
435 FRlist-CantRecovFile2 Two files are being mapped to the same
target file from the mapping specified
436 FRlist-CantRecovFile3 Specified file could not be recovered
because it is now being audited to a different
audit trail than it was when it was dumped
Table 6-3. Recovery Event Messages (page 3 of 4)
Event # Symbolic Name (ZTMF-EVT-) Description