TMF Management Programming Manual (H06.06+, J06.03+)
Table Of Contents
- HP NonStop TMF Management Programming Manual
- Legal Notices
- Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction to TMF
- 2 Communicating With the TMFSERVE Process
- 3 SPI Programming Considerations for TMF
- 4 Common Definitions
- 5 Commands and Responses
- Command Summary
- Command Descriptions
- ABORT TRANSACTION
- ADD AUDITTRAIL
- ADD DATAVOLS
- ADD DUMPS
- ADD MEDIA
- ADD RESOURCEMANAGER
- ALTER AUDITDUMP
- ALTER AUDITTRAIL
- ALTER BEGINTRANS
- ALTER CATALOG
- ALTER DATAVOLS
- ALTER DUMPS
- ALTER MEDIA
- ALTER PROCESS
- ALTER TMF
- CANCEL OPERATION
- CLOSE RESOURCEMANAGER
- DELETE CATALOG
- DELETE DATAVOLS
- DELETE DUMPS
- DELETE MEDIA
- DELETE RESOURCEMANAGER
- DELETE TMF
- DELETE TRANSACTION
- DISABLE AUDITDUMP
- DISABLE BEGINTRANS
- DISABLE DATAVOLS
- DUMP FILES
- ENABLE AUDITDUMP
- ENABLE BEGINTRANS
- ENABLE DATAVOLS
- INFO ATDUMPDM
- INFO ATVOLUME
- INFO AUDITDUMP
- INFO AUDITTRAIL
- INFO BEGINTRANS
- INFO CATALOG
- INFO DATAVOLS
- INFO DUMPS
- INFO MEDIA
- INFO PROCESS
- INFO RESOURCEMANAGER
- INFO TMF
- LIST AUDITTRAIL
- NEXT AUDITTRAIL
- RECOVER FILES
- RELOCATE DISKDUMPS
- RESOLVE TRANSACTION
- START TMF
- STATUS ATFILE
- STATUS AUDITDUMP
- STATUS AUDITTRAIL
- STATUS BEGINTRANS
- STATUS CATALOG
- STATUS DATAVOLS
- STATUS OPERATION
- STATUS RESOURCEMANAGER
- STATUS RMTRANSBRANCHES
- STATUS TMF
- STATUS TMFSERVER
- STATUS TRANSACTION
- STATUS TRANSACTIONCHILDREN
- STOP TMF
- 6 Event Messages
- 7 Error and Warning Messages
- A TMF Configuration Limits and Defaults
- Index
Event Messages
HP NonStop TMF Management Programming Manual—540140-010
6-353
Descriptions of Event Messages
330: ZTMF-EVT-AlterSessionIdleTimer
This event is issued whenever the session idle timer is set to a new value by using the
SNOOP SetSessionIdleTmr command. A transaction that spans two or more network
nodes causes the establishment of a peer-to-peer session between the $TMP
processes on each node. The session idle timer value is the number of seconds a
session between the $TMP processes can exist with no transaction activity before the
session is disconnected.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType
is the subject of the event message, and it identifies the TMF process that
generated the event. The value of this token for this event is ZTMF-VAL-PROC-
TMP.
ZTMF-TKN-SessIdleTimer
is the new session idle timer value. A value of zero disables the session idle timer.
The positive range for this timer is 300 seconds (5 minutes) to 1020 seconds (17
minutes).
Effect
None.
Recommended Action
Informational message only; no corrective action is needed. This message merely
indicates that someone has executed a SNOOP SetSessionIdleTmr command.
Additional Unconditional Tokens
ZTMF-TKN-EVTHDR-ProcessType token-type ZSPI-TYP-Enum.
ZTMF-TKN-SessIdleTimer token-type ZSPI-TYP-Int.
ZEMS-TKN-Emphasis token-type ZSPI-TYP-Boolean.
Event-Message Text
If ZTMF-TKN-SessIdleTimer is greater than zero:
The session idle timer has been altered to ZTMF-TKN-
SessIdleTimer seconds.
If ZTMF-TKN-SessIdleTimer is zero:
The session idle timer has been disabled.