TMF Management Programming Manual (H06.06+, J06.03+)
Table Of Contents
- HP NonStop TMF Management Programming Manual
- Legal Notices
- Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction to TMF
- 2 Communicating With the TMFSERVE Process
- 3 SPI Programming Considerations for TMF
- 4 Common Definitions
- 5 Commands and Responses
- Command Summary
- Command Descriptions
- ABORT TRANSACTION
- ADD AUDITTRAIL
- ADD DATAVOLS
- ADD DUMPS
- ADD MEDIA
- ADD RESOURCEMANAGER
- ALTER AUDITDUMP
- ALTER AUDITTRAIL
- ALTER BEGINTRANS
- ALTER CATALOG
- ALTER DATAVOLS
- ALTER DUMPS
- ALTER MEDIA
- ALTER PROCESS
- ALTER TMF
- CANCEL OPERATION
- CLOSE RESOURCEMANAGER
- DELETE CATALOG
- DELETE DATAVOLS
- DELETE DUMPS
- DELETE MEDIA
- DELETE RESOURCEMANAGER
- DELETE TMF
- DELETE TRANSACTION
- DISABLE AUDITDUMP
- DISABLE BEGINTRANS
- DISABLE DATAVOLS
- DUMP FILES
- ENABLE AUDITDUMP
- ENABLE BEGINTRANS
- ENABLE DATAVOLS
- INFO ATDUMPDM
- INFO ATVOLUME
- INFO AUDITDUMP
- INFO AUDITTRAIL
- INFO BEGINTRANS
- INFO CATALOG
- INFO DATAVOLS
- INFO DUMPS
- INFO MEDIA
- INFO PROCESS
- INFO RESOURCEMANAGER
- INFO TMF
- LIST AUDITTRAIL
- NEXT AUDITTRAIL
- RECOVER FILES
- RELOCATE DISKDUMPS
- RESOLVE TRANSACTION
- START TMF
- STATUS ATFILE
- STATUS AUDITDUMP
- STATUS AUDITTRAIL
- STATUS BEGINTRANS
- STATUS CATALOG
- STATUS DATAVOLS
- STATUS OPERATION
- STATUS RESOURCEMANAGER
- STATUS RMTRANSBRANCHES
- STATUS TMF
- STATUS TMFSERVER
- STATUS TRANSACTION
- STATUS TRANSACTIONCHILDREN
- STOP TMF
- 6 Event Messages
- 7 Error and Warning Messages
- A TMF Configuration Limits and Defaults
- Index
Commands and Responses
HP NonStop TMF Management Programming Manual—540140-010
5-12
ADD AUDITTRAIL
Tokens in Response Buffer
ZTMF-TKN-VolumeName
contains the name of a volume that was in error, if an error is returned.
ZTMF-TKN-ATVolumeType
contains the type of the volume specified in ZTMF-TKN-VolumeName. This
token is only present if ZTMF-TKN-VolumeName is present. The following
values are valid:
ZTMF-TKN-FS-Error
contains the file-system error that may have caused the command to fail. Its
presence depends on the value of ZSPI-Ret-Code.
Usage Guidelines
Only super-group users can issue this command.
You can issue ADD AUDITTRAIL commands under either of the following conditions:
1. Before you start TMF for the first time with the START TMF command.
2. After TMF is started. At this point, however, you can only configure auxiliary audit
trails.
Under either condition you can issue multiple ADD AUDITTRAIL commands.
For more information on the ADD AUDITTRAIL command, see the TMF Reference
Manual.
ZTMF-VAL-ActiveVol The disk volume that holds the audit trail
files.
ZTMF-VAL-OverflowVol The disk volume used as overflow space
for the audit trail.
ZTMF-VAL-RestoreVol The disk volume used when restoring audit
dumps.
Note. Before entering the START TMF command, you must configure at least one audit
trail, the master audit trail. At this time, in addition, you can configure as many auxiliary
audit trails as you wish, up to the limit of 15.