TMF Management Programming Manual (H06.06+, J06.03+)
Table Of Contents
- HP NonStop TMF Management Programming Manual
- Legal Notices
- Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction to TMF
- 2 Communicating With the TMFSERVE Process
- 3 SPI Programming Considerations for TMF
- 4 Common Definitions
- 5 Commands and Responses
- Command Summary
- Command Descriptions
- ABORT TRANSACTION
- ADD AUDITTRAIL
- ADD DATAVOLS
- ADD DUMPS
- ADD MEDIA
- ADD RESOURCEMANAGER
- ALTER AUDITDUMP
- ALTER AUDITTRAIL
- ALTER BEGINTRANS
- ALTER CATALOG
- ALTER DATAVOLS
- ALTER DUMPS
- ALTER MEDIA
- ALTER PROCESS
- ALTER TMF
- CANCEL OPERATION
- CLOSE RESOURCEMANAGER
- DELETE CATALOG
- DELETE DATAVOLS
- DELETE DUMPS
- DELETE MEDIA
- DELETE RESOURCEMANAGER
- DELETE TMF
- DELETE TRANSACTION
- DISABLE AUDITDUMP
- DISABLE BEGINTRANS
- DISABLE DATAVOLS
- DUMP FILES
- ENABLE AUDITDUMP
- ENABLE BEGINTRANS
- ENABLE DATAVOLS
- INFO ATDUMPDM
- INFO ATVOLUME
- INFO AUDITDUMP
- INFO AUDITTRAIL
- INFO BEGINTRANS
- INFO CATALOG
- INFO DATAVOLS
- INFO DUMPS
- INFO MEDIA
- INFO PROCESS
- INFO RESOURCEMANAGER
- INFO TMF
- LIST AUDITTRAIL
- NEXT AUDITTRAIL
- RECOVER FILES
- RELOCATE DISKDUMPS
- RESOLVE TRANSACTION
- START TMF
- STATUS ATFILE
- STATUS AUDITDUMP
- STATUS AUDITTRAIL
- STATUS BEGINTRANS
- STATUS CATALOG
- STATUS DATAVOLS
- STATUS OPERATION
- STATUS RESOURCEMANAGER
- STATUS RMTRANSBRANCHES
- STATUS TMF
- STATUS TMFSERVER
- STATUS TRANSACTION
- STATUS TRANSACTIONCHILDREN
- STOP TMF
- 6 Event Messages
- 7 Error and Warning Messages
- A TMF Configuration Limits and Defaults
- Index
Error and Warning Messages
HP NonStop TMF Management Programming Manual—540140-010
7-63
Archive Tape Errors and Warnings
8107 Found a regular labeled tape.
The tape is a labeled tape, but not a TMF archive tape.
8108 Found a pre-C00 TMF tape.
The tape is a pre-C00 TMF archive tape.
8109 Tape is not a TMF Archive tape.
The tape is not a TMF archive tape.
8113 Wrong tape mounted (Found tape # ZART-TKN-TAPENUM, expected
tape #ZART-TKN-EXPECTEDTAPENUM).
The mounted tape is not the one that was expected.
8115 EOF mark was not found after the Archive volume label set.
The tape format is invalid.
8116 Bad length for standard tape header label.
The tape format is invalid.
8117 Standard tape header label not found.
The tape format is invalid.
8118 Standard tape header is out of sequence.
The tape format is invalid.
8119 File-system error ZART-TKN-TAPEFILEERROR occurred on the first
I/O operation attempted.
A file-system error occurred while a dump or restore process was attempting the
first I/O operation.
8120 Labeled tape mounted for input is a scratch tape.
A tape that has been labeled or relabeled and has no data was mounted for
reading.
8121 Tape parity errors and/or tape record checksum errors were found
on the beginning volume labels.
Parity and/or checksum errors occurred on the beginning volume labels. Such
errors might be caused by the beginning of the tape being worn out, or to dirty
tape drive heads.