TR3271 Management Programming Manual

COMMANDS AND RESPONSES
LOAD Command
ZSPI-TKN-SERVER-VERSION indicates the software release version of
the TR3271 subsystem. See "SPI Standard Definitions" in Section
5 for details.
ZSPI-TKN-DATALIST indicates the beginning of a data list. See
"SPI Standard Definitions" in Section 5, "Common Definitions,"
and the Distributed Systems Management (DSM) Programming Manual .
ZCOM-TKN-OBJNAME specifies the name of the TR3271 line for which
the CLIP was downloaded. Unless there is an error that prevents
the LOAD command from being attempted at all, this token is
present in every response record. ZCOM-TKN-OBJNAME is described
in "Data-Communications Standard Definitions" in Section 5 and
the Communications Management Programming Manual .
ZCOM-TKN-OBJTYPE specifies the type of object that was loaded.
This token must have the value ZCOM-OBJ-LINE. This token is
described in Section 5, "Common Definitions," and the
Communications Management Programming Manual .
ZSPI-TKN-ERRLIST indicates the beginning of an error list. See
"SPI Standard Definitions" in Section 5 for details.
ZSPI-TKN-RETCODE specifies the return code for the command. This
token is described in "SPI Standard Definitions" in Section 5
and the Distributed Systems Management (DSM) Programming Manual .
For details on the data-communications error numbers and their
associated error lists, see "Common Error Numbers and Error
Lists" in the Communications Management Programming Manual .
The possible nonzero values of RETCODE in response to the LOAD
command are as follows:
ZCOM-ERR-EMPT-RSP (-33)
ZCOM-ERR-TKN-VAL-INV (-30)
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SECUR-VIOL (-22)
ZCOM-ERR-OBJNAME-INV (-19)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-FNAME-INV (-9)
ZCOM-ERR-CMD-TIMED-OUT (-7)
ZCOM-ERR-CMD-MISMATCH (-4)
ZCOM-ERR-CMD-INV-IN-SUMSTATE (-3)
Your management application tried to load a line that was
not in the STOPPED summary state. The line cannot be in
the STARTED or DIAGNOSING summary state when this command is
issued.
6-70