TS/MP 2.5 System Management Manual

11 PATHMON Environment Control Commands
This section describes the PATHCOM commands that control the PATHMON process and the
PATHMON environment as a whole; the commands are listed in alphabetic order. The PATHMON
environment control commands are as follows:
Use These PATHCOM Commands…To Perform These Tasks…
SET PATHWAY
SET PATHMON
Define attribute values
CONTROL PATHMONChange attribute values
START PATHWAY
STOP PATHMON
Change process states
SHUTDOWN
SHUTDOWN2
INFO PATHWAY
INFO PATHMON
Obtain information about
STATUS PATHWAY
STATUS PATHMON
STATUS LINKMON
LOG1
LOG2
Perform other management tasks
PRIMARY PATHMON
SWITCH PATHMON
These commands define the PATHMON configuration and control basic PATHMON environment
operations. With these commands you can:
• Start and stop PATHMON environment operations
• Designate and change the processor where the PATHMON backup process runs
• Set the limits for the number of PATHMON-controlled objects
• Specify the PATHMON process logging requirements
• Display PATHMON object attributes and status information
The only PATHCOM command for the ACS subsystem is STATUS LINKMON. For more information
about ACS subsystem processes, see the Introduction to NonStop Transaction Processing. For a
list of PATHCOM commands that you to perform functions related to ACS subsystem processes,
see “Overview of PATHCOM” (page 126). For detailed information about ACS subsystem processes
and their use with Pathsend requestors, see the TS/MP 2.5 Pathsend and Server Programming
Manual.
NOTE: When using TS/MP 2.5, HP recommends that you must use PDMCOM instead of
PATHCOM, because it can communicate with multiple PATHMONs simultaneously. For more
information on PDMCOM, see the TS/MP 2.5 Release Supplement.
150 PATHMON Environment Control Commands