TS/MP 2.5 System Management Manual

ManualsBrandsHP ManualsServerHP Integrity NonStop H-Series

221

222

223

224

225

226

227

228

229

230

Cause. A PATHMON process internal-consistency check failed. This is an internal error.

Effect. The PATHMON process terminates.

If the DUMP attribute is d, the PATHMON process creates a dump file before terminating.

Recovery. Contact your HP representative and provide all relevant information as follows:

• Descriptions of the problem and accompanying symptoms

• Details from the messages generated

• Your PATHMON configuration file and the PATHMON process version

• A description of the application task that was in progress when the error was encountered

• Supporting documentation such as Event Management Service (EMS) logs, trace files, and

dump files, if applicable

If your local operating procedures require contacting the Global Customer Support Center (GCSC),

supply your system number and the numbers and versions of all related products as well.

1079

*1079* NO STATIC SERVERS DEFINED

Cause. A START SERVER command failed because the SET SERVER NUMSTATIC attribute is set

to 0.

Effect. The PATHMON process cannot start a server process until it receives a request from a the

ACS subsystem process or a TCP.

Recovery. Define the SET SERVER NUMSTATIC attribute with a value from 1 through 4094.

1080

*1080* PATHMON, TRAP: T=%trap S=%s-reg P=%p-reg E=%e-reg L=%l-reg

Cause. A software or hardware failure resulted in a trap. This is an internal error. These values

give the process environment at the time the PATHMON process failed:

is the number of the trap for use with DEBUG%trap-no

is the stack register%s-reg

is the program counter register%p-reg

is the environment register%e-reg

is the local register%l-reg

Effect. The PATHMON process terminates. If possible, it creates a dump file.