TS/MP 2.5 System Management Manual

Recovery. Informational message only; no corrective action is needed.
LINKMON cannot be run
Cause. You attempted to start a LINKMON process with a RUN command.
Effect. The LINKMON process terminates processing.
Recovery. There is no way to recover from this error condition; you cannot start a LINKMON
process with a RUN command.
SEGMENT_ALLOCATE_ error error-number [ (error detail error-detail) ] on swap file swap-file-name
Cause. An error occurred when the LINKMON process attempted to create an extended memory
segment. If SEGMENT_ALLOCATE_ returned error 1, 2, 3, or 14, the message includes error detail
information.
Effect. The LINKMON process is unable to process SERVERCLASS_SEND_ calls.
Recovery. Recovery depends on the file error that occurs. For example, error 1 with error detail
FENODISCSPACE (43) indicates that the specified disk does not contain enough free space for
the swap file. You must make additional disk space available before the LINKMON process can
initialize itself. Each subsequent SERVERCLASS_SEND_ call in this processor causes the LINKMON
process to reattempt initialization; after the condition is corrected, the LINKMON process can
complete initialization.
Terminating
Cause. The LINKMON process has terminated.
Effect. The LINKMON process is no longer able to support SERVERCLASS_SEND_ calls in its
processor.
Recovery. This message is not expected during normal operation. If you receive this message,
contact your HP representative.
Unable to purge existing swap file swap-file-name
(file purge error error-number)
Cause. A file-system error occurred when the LINKMON process attempted to purge an old extended
memory swap file.
Effect. The LINKMON process is unable to process SERVERCLASS_SEND_ calls.
Recovery. This message is not expected during normal operation. Recovery depends on the file
error that occurs. Each subsequent SERVERCLASS_SEND_ call in this processor causes the LINKMON
process to reattempt initialization; after the condition is corrected, the LINKMON process can
complete initialization.
Unable to secure swap file file-name ( reason )
Cause. A file-system error occurred when the LINKMON process attempted to secure its extended
memory swap file.
Effect. The LINKMON process is unable to process SERVERCLASS_SEND_ calls.
Recovery. This error is not expected during normal operations. Recovery depends on the file error
that occurs. For example, if you receive a file in use error (12), ensure that the file is available
before issuing another SERVERCLASS_SEND_ call in this processor. Each subsequent
LINKMON Log Messages 273