TS/MP Release Supplement

Installing and Configuring

HP NonStop TS/MP Release Supplement—546055-006

6-2

Installing TS/MP 2.3 / 2.4 versions

Use the standard Distributed Systems Management/Software Configuration Manager

(DSM/SCM) installation tool to install TS/MP 2.3 or TS/MP 2.4.

Perform the following steps to install TS/MP 2.3:

1. RECEIVE the SPR of TS/MP from disk or tape.

2. COPY to a new software revision of the configuration you want to update.

3. Ensure that products T0620 (ACS Infrastructure), T0639 (Pathsend Library), and

T0845 (Pathway Domain Mgmt Interface) are present in the product list of the

software revision window.

4. BUILD and APPLY the configuration revision.

5. Run ZPHIRNM to perform the RENAME step.

After executing the above steps, the ACS components are automatically installed in the

$SYSTEM.SYSnn directory. Perform the following post installation steps:

1. If the system is running TS/MP 2.0 LINKMON or ROUT product, rename the

TS/MP 2.3 ROUT program file. See Migration Considerations

on page 6-2.

2. Perform a system load on the system image created.

3. If TS/MP 2.0 LINKMON or ROUT product is installed on the system, delete its

configuration using SCF, and rename TS/MP 2.3 ROUT file back to ROUT. See

Migration Considerations

on page 6-2.

4. Configure and start the ACS subsystem using SCF. See Configuring and Starting

the ACS Subsystem on page 6-5.

5. Start Pathway systems. Pathway systems may be cool started after the installation.

See Starting TS/MP PATHMON and Requesters on page 6-8.

Migration Considerations

•

Perform the following instructions if TS/MP 2.3 is being installed on a system that

has TS/MP 2.0 LINKMON or ROUT installed and running.

a. On HP Integrity NonStop servers, the TS/MP 2.0 LINKMON or ROUT process

is added directly under the Persistence Manager $ZZKRN process using the

SCF ADD PROCESS command. The

$ZZKRN process maintains a persistent

table of its own where it maintains all added entries. An added entry remains in

the table (until it is explicitly deleted using SCF DELETE PROCESS command)

irrespective of the number of sysgens and processor reloads performed. The

SCF ADD PROCESS command for TS/MP 2.0 LINKMON or ROUT directs the

Note. The installation procedure for TS/MP 2.4 is exactly the same as that for TS/MP 2.3. The

following procedure uses TS/MP 2.3 as an example to describe the steps, however you can

follow the same steps to install TS/MP 2.4.