TS/MP Release Supplement

Installing and Configuring
HP NonStop TS/MP Release Supplement—546055-006
6-5
Configuring and Starting the ACS Subsystem
c. Change the name of the renamed TS/MP 2.3 ROUT program file in the latest
SYSnn subvolume, back to ROUT, as follows:
TACL>RENAME $SYSTEM.<SYSnn>.<renamed-file>,
$SYSTEM.<SYSnn>.ROUT
•
The TS/MP 2.0 LINKMON or ROUT process in each processor is started
implicitly when the processor is initially loaded or reloaded. The TS/MP 2.3
processes in each processor are started when the ACS subsystem is started. The
subsystem must be started by an explicit operator command, or by an explicit
command in a system startup command file. The ACS subsystem manager
process automatically restarts the ACS subsystem processes in a processor that
has been reloaded.
•
If TS/MP 2.3 is installed on a system that has TS/MP 2.0 or TS/MP 2.1, the
Pathway systems must be cold started.
•
There are no additional instructions if TS/MP 2.3 is being installed on a system that
has TS/MP 2.1 ROUT installed and running.
Configuring and Starting the ACS Subsystem
Starting SCF
This step starts the SCF management interface, which is typically located in the file
$SYSTEM.SYSTEM.SCF.
Procedure:
Use the
TACL RUN command interactively or in an OBEY file, as follows:
1. SCF
After SCF is started, you can use the SETPROMPT command to change the prompt.
Configuring the Domain Coordinator Process ($ZACS)
This step adds the ACS domain coordinator process ($ZACS) to the configuration
database (
CONFIG) on the physical system that contains the ACS components and
configures it.
Procedure:
Use the
SCF ADD PROCESS command interactively or in an OBEY file. For example:
ASSUME PROCESS $ZZKRN
ADD PROCESS #ZACS, &
NAME $ZACS, &
PROGRAM $SYSTEM.SYSnn.BC, &
DEFAULTVOL $SYSTEM.SYSnn, &
PRIMARYCPU primary-cpu, &
STARTUPMSG "num", &
STARTMODE startmode, &