TS/MP Release Supplement

Managing the ACS Subsystem
HP NonStop TS/MP Release Supplement—546055-006
7-3
Restarting the ACS Subsystem
the ACS subsystem, not the ACS subsystem configuration. For more information on
this command, see CONTROL Command
. For example:
CONTROL ACS $ZACS, PROCESSORLIST (2, 3), ENABLE
Restarting the ACS Subsystem
A complete description for configuring and starting the ACS subsystem during
installation of TS/MP 2.3 (or later version) is described in Section 6, Installing and
Configuring.To restart the subsystem when it is in the STOPPED state, follow these
steps:
1. Start $ZACS
1. Use the SCF STATUS PROCESS command to check whether the $ZACS process
has started. For example:
STATUS PROCESS $ZZKRN.#ZACS, DETAIL
2. Use the SCF START command interactively or in an OBEY file to start the $ZACS
process:
ASSUME PROCESS $ZZKRN
START #ZACS
3. Use the SCF STATUS command, described in Step 1, to verify that the $ZACS
process has started.
2. Start the ACS Subsystem
1. Use the SCF START command to start the ACS subsystem.
For more information on this command, see START Command
. For example:
START ACS $ZACS
Use the SCF STATUS command to verify that the ACS subsystem has started.
For more information on this command, see STATUS Command
. For example:
STATUS ACS $ZACS, DETAIL
Stopping the ACS Subsystem
If you are stopping the subsystem to change the configuration, you need to perform
Step 2 only. If you want to remove the TS/MP 2.3 (or later version) from your system,
perform all of the following steps.
1. Stop the Pathsend Requesters
For information on stopping Pathsend Requesters, see the TS/MP System
Management Manual.