TS/MP Supplement for Limits Relief (H06.05+, J06.03+)

2. If $ZACS is not started,
start it.
Use the SCF START command interactively or in an OBEY file, as
follows:
ASSUME PROCESS $ZZKRN
START #ZACS
3. Verify that $ZACS is
started.
Use the SCF STATUS command as described in Step 1.
3. Start the ACS Subsystem
1. Start the ACS subsystem.
Use the SCF START command. For detailed information
about this command, see START in Chapter 7. For
example:
START ACS $ZACS
2. Verify the ACS subsystem is started.
Use the SCF STATUS command. For detailed
information about this command, see STATUS in
Chapter 7. For example:
STATUS ACS $ZACS, DETAIL
4. Restart the Pathsend Requesters
For information on starting Pathsend requesters, see the TS/MP System Management Manual.
Stopping the Subsystem
1. Stop the Pathsend Requesters
2. Stop the ACS Subsystem
3. Stop $ZACS
4. Delete the $ZACS Process Configuration
If you are stopping the subsystem to change the configuration, you need to perform Step 1 and
Step 2 only. If you are preparing to remove TS/MP 2.1, you need to perform all the following
steps.
1. Stop the Pathsend Requesters
Stop the Pathsend requesters. See the TS/MP System Management Manual.