TS/MP Supplement for Limits Relief (H06.05+, J06.03+)

local system:
START ACS $ZACS
The following START command initiates the process of starting the ACS subsystem on the
remote system \PLUTO:
START ACS \PLUTO.$ZACS
STATUS
Use the STATUS command to display the current operational status of the ACS subsystem. The
information displayed depends upon the state of the ACS subsystem, including any
modifications specified by the CONTROL command.
This is a nonsensitive command.
Syntax Summary.
STATUS [ /OUT file-spec/ ] [ object-spec ] [ , DETAIL ]
Syntax Descriptions.
OUT file-spec
specifies a file for the output of this command. The file can be on the same physical
system as the ACS subsystem or on any system in the same Expand network.
object-spec
specifies the name of the ACS object. The fully qualified object-spec has the format:
[ ACS ] [ system-name.]$ZACS
system-name is the physical, Guardian name of the system in which the object is
being added and configured.
If you specify the SCF object type (ACS) or any portion of the object name (
acs-spec) in a prior ASSUME command, you can omit it in this command. For
information about the ASSUME command, see the SCF Reference Manual for G-Series
RVUs or the SCF Reference Manual for H-Series RVUs.
If you have not used a prior ASSUME command and you omit system-name, the
command defaults to the local physical system.
DETAIL
specifies that the display is to include additional detail information.
Display Format With DETAIL Option.
ACS Domain: domain-name
System Status Processor Status