TS/MP System Management Manual (H06.05+, J06.03+)

Overview of PATHCOM
HP NonStop TS/MP System Management Manual—541819-007
8-2
Command List
The relationships illustrated in Figure 8-1 apply for all of the PATHCOM commands and
the PATHMON-controlled objects. Some PATHCOM commands affect only certain
objects and their operation. For example, the CONTROL command affects only the
PATHMON process and the FREEZE SERVER command affects only server classes.
Command List
Table 8-1 is a list of the commands you can run using PATHCOM. The table entries
provide the name of the command, its description, and the names of the objects
influenced by the command.
Note. The CONTROL TERMs command must be issued when TERM is in the STOPPED
state for COUPLE request.
Note. The PATHMON process reports only destination object states; it does not report
transitional states. To determine the current state of an object, use the appropriate STATUS
command.
Note. The commands in this table pertain only to objects managed through the NonStop
TS/MP product. For commands for objects managed under the Pathway/iTS product, see
Pathway/iTS System Management Manual.
Table 8-1. PATHCOM Commands (page 1 of 3)
PATHCOM
Commands Description Valid Objects
ADD Enters a description of an object into the
configuration
SERVER
ALTER Changes the attributes of a previously
defined object while the object is stopped
SERVER
CMDCWD Sets the default absolute OSS directory
for expansion of any OSS process file
names.
CMDVOL Sets the default volume and subvolume
for expansion of any Guardian process file
names except Command file names
CONTROL* Changes the attributes of an object while
it is running
PATHMON process
DELETE Removes an object description from the
system configuration
SERVER
ERRORS Enables PATHCOM to continue executing
commands after encountering a specified
number of errors
*The CONTROL TERMs command must be issued when TERM is in the STOPPED state for COUPLE
request.