TS/MP System Management Manual (H06.05+, J06.03+)

PATHCOM Operation Commands
HP NonStop TS/MP System Management Manual—541819-007
10-10
HISTORY Command
In response, PATHCOM displays the syntax for a TERM parameter list as:
<termname-list> ::=
TERM * [ [ , <termqualifier> ] ... ]
[ TERM ] <name-list>
To obtain syntax for the <termqualifier> parameter of the SUSPEND command, enter:
HELP <termqualifier>
In response, PATHCOM displays the syntax for a TERM qualifier as follows:
<termqualifier> ::=
{ SEL } [ NOT ] { RUNNING }
{ STATE } { STOPPED }
{ SUSPENDED }
TCP <name>
Entering an error number with the HELP command as follows:
HELP 3019
causes PATHCOM to display the corresponding message text:
PATHTCP ERROR - *3019* WRONG TRANSFER COUNT IN TERMINAL IO
HISTORY Command
Use the HISTORY command to display previous PATHCOM commands.
number
is the number of earlier commands you want to retrieve. The default value is 10.
Consideration
•
If you omit number, the HISTORY command displays the last ten commands.
•
If number is greater than the number of commands issued previously, the
HISTORY command displays all the commands.
•
The HISTORY command displays the command numbers for each command. You
can use command numbers in the FC and ! commands.
•
The HISTORY command can display a maximum of ten commands.
HISTORY [ number ]
Note. The HISTORY command is supported by TS/MP 2.4 and is available only on systems
running J06.05 and later J-series RVUs and H06.16 and later H-series RVUs.