TS/MP System Management Manual (H06.05+, J06.03+)

PATHMON Environment Control Commands
HP NonStop TS/MP System Management Manual—541819-007
11-21
SET PATHWAY Command
OWNER ownerid
is the user ID allowed to issue PATHCOM commands that directly alter the state of
the PATHMON-controlled objects. The user ID must be known to the system in
which PATHCOM is running. Use this attribute in conjunction with the SECURITY
attribute.
The value of ownerid is one of these:
[ \system-number | \*.] group-number, user-number
[ \node | \* .] group-name . user-name
If the NODEINDEPENDENT attribute of the SET PATHWAY command is set to ON
and you omit the node name, or if you specify \* for the ownerid node name or
system number, the value is whatever node the PATHMON process is running on
after cool start. The group-name and user-name are configured as you
specify. For more on the \* name, see the description of the SET PATHWAY
NODEINDEPENDENT command, earlier in this section.
If the NODEINDEPENDENT attribute of the SET PATHWAY command is set to
OFF and you omit the node name (or system number) parameter, the node value
defaults to PATHMON’s node, and the group-name and user-name are
configured as you specify.
If you omit this attribute, the node value defaults to PATHMON’s node, and the
group-name and user-name values default to the user ID values of the user
who started the PATHMON process. (This attribute does not use the defaults
established by the CMDVOL command.)
SECURITY security-attribute
specifies the users who can issue PATHCOM commands that directly alter the
state of the PATHMON-controlled objects. Before you issue the START PATHWAY
command, the owner ID is the process-accessor ID of the PATHMON process.
This security setting prevents alteration of the Pathway configuration attributes.
The security attributes are the same as the Guardian security attributes. The
possible values are:
“A” Any local user
“G” A group member or owner
“O” Owner only
“-” Local super ID