TS/MP System Management Manual (H06.05+, J06.03+)

PATHMON Messages (Numbers 1000-1499)
HP NonStop TS/MP System Management Manual—541819-007
13-5
PATHMON Messages
Effect. The operation fails.
Recovery. Stop the PATHMON environment before changing the configuration.
1010
Cause. An attempt was made to run a command while the PATHMON process was
not in the RUNNING state. Only the SET PATHMON and SET PATHWAY commands
can be run while the PATHMON process is not running.
Effect. The command fails.
Recovery. Configure the PATHMON environment.
1011
Cause. An error occurred while a TCP or LINKMON process was trying to return a link
to a server class. The nested message indicates the reason for the failure.
Effect. The effect depends on the reason for the failure.
Recovery. For additional information, see the description associated with the nested
message.
1012
Cause. Either the PATHMON process tried to add an object having a name that
already exists, or the PATHMON process tried to start a TCP or server process using a
process name that is already active within this PATHMON environment.
This message usually indicates that there was an attempt to use an object name or a
process name twice. For example, if this is a nested message in a CAN’T GRANT
LINK error (for more information, see the description of error 1007), the process name
for a dynamic server already exists in the list of active server processes and TCPs for
the PATHMON process.
Effect. The object is not added, or the TCP or server process is not started.
Recovery. Check the object name or the process name associated with the specified
object. Change the name as needed.
*1010* PATHWAY NOT CONFIGURED
*1011* link manager-name, DELINK FAILURE : < nested-message >
*1012* object-name, ENTRY ALREADY EXISTS