ViewPoint Manual
Definition of ViewPoint Screens
ViewPoint Manual—426801-001
3-35
Field Descriptions
Table 3-9. Only certain display types can be broken down this way into separate
objects.
5. Server Class. Name of the server class that is responsible for the display type
defined in Table 3-3. Each status server class has its own collection of display
types.
6. Under PATHMON. Normally this field is blank and the default name assumes the
name of the server class that belongs to the Pathway system in which the current
ViewPoint session is operating. However, you can obtain status from a server class
that belongs to some other Pathway system; in that case, you must identify its
PATHMON in this field, using the network form of the process name if it is a
remote PATHMON.
7. Use Maximum for 100%. This is a one-character field where you enter a Y (yes)
or an N (no), but only for status items that provide a count of objects. “Yes” means
use the configured maximum count of objects as the basis for computing percentage
on the Network Status Summary screen. “No” means use the value given in the next
field as the basis. You might want to do this if a predictable number of objects are
typically down or offline, or to improve resolution in cases where percentages are
typically very low.
8. Value. If you entered N in the preceding field, specify your desired value in this
field for the percentage computation basis.
9. Enable Lower Threshold. This is a one-character field where you enter a Y (yes)
or an N (no). Entering a “Y” means highlight this line on the Network Status
Summary screen when the computed percentage value falls below the percentage
value stated in the next field (lower threshold value). “No” means ignore any lower
threshold setting.
10. Value. If you entered Y in the preceding field, specify your desired value in this
field for a lower threshold setting.
Table 3-9. Object Names for Display Types
Display Type Object Name
CPU-busy 0-15
Average-CPU-Busy None
Disk-busy Device name
Line-busy Device name
PATHWAY-term PATHMON process name
SNAX-lines-up $SSCP
SNAX-PUs-up $SSCP
SNAX-LUs-up $SSCP
TMF-transaction-rate None