Virtual Hometerm Subsystem (VHS) Manual (H06.03+)

VHSCI Messages
Virtual Hometerm Subsystem (VHS) Manual—429311-001
G-18
Message Descriptions
VHS 20111
Probable Cause. Too many object names were specified in a single command.
Recommended Action. Split the object names into two commands.
VHS 20112
Probable Cause. This message informs the user that processing has been terminated
because the maximum number of errors set by the ALLOW command has been
exceeded.
Recommended Action. Either correct the conditions that are causing the errors or
increase the number of allowable errors with the ALLOW command.
VHS 20113
Probable Cause. This message informs the user that processing has been terminated
because the maximum number of warnings set by the ALLOW command has been
exceeded.
Recommended Action. Either correct the conditions that are causing the warnings or
increase the number of allowable warnings with the ALLOW command.
VHS 20114
Probable Cause. The ASSIGN/PARAM command or ASSIGN/PARAM message
cannot be processed because the allocated space was exceeded.
Recommended Action. Clear unneeded ASSIGNs/PARAMs by using the CLEAR
command.
VHS 20116
Probable Cause. The home terminal was unavailable.
Recommended Action. If the home terminal was specified in the RUN command, then
specify a different home terminal; otherwise, consult your system manager.
The size of the specified object names exceed the allocated
space
Maximum number of allowable errors exceeded
Maximum number of allowable warnings exceeded
ASSIGN/PARAM message exceeds allocated space
NEWPROCESS error 16: I/O error on home terminal