Virtual Hometerm Subsystem (VHS) Manual (H06.03+)

Installing VHS
Virtual Hometerm Subsystem (VHS) Manual—429311-001
2-14
Installing the VHS Browser in ViewPoint
7. Creating the VHS Startup File
The INSTVHS routine creates the VHS startup file with the name specified by the
VHS-STARTUP-FILE parameter.
When all of the above steps are completed successfully, the installation of the VHS
and VHSCI programs and the VHS GUI Agent facility is complete and you can
continue with the installation of the VHS Browser facility.
Installing the VHS Browser in ViewPoint
To install the VHS Browser facility into ViewPoint, you run the INSTVHS routine and
follow the directions (see Figure 2-3).
Before you run INSTVHS, review Table 2-4 for the parameters you must provide during
the installation.
Figure 2-3. Installing the VHS Browser in ViewPoint
Note. If you plan to install the VHS Browser facility in ViewPoint later, then you must be the
owner of ViewPoint and ViewPoint must be running on your terminal. For example, if you want
to install the VHS Browser facility within ViewPoint, invoke ViewPoint by typing this at the TACL
prompt:
2> viewpt
Browser
Install Browser in
ViewPoint
environment
Use option 2 of
the INSTVHS
routine
No
stand-alone?
VST023.vsd