Virtual Hometerm Subsystem (VHS) Manual (H06.03+)

Installing VHS
Virtual Hometerm Subsystem (VHS) Manual—429311-001
2-29
Modifying the VHS Configuration Files
VHS Browser Stand-Alone Pathway Configuration Files
When you install the VHS Browser as a stand-alone Pathway system, several files are
created. Table 2-6 lists all the files created. Three Pathway configuration files are
important to note:
The VHS Browser facility is added and started automatically whenever you start your
Pathway system cold.
Security Considerations
The VHS Browser facility does not provide its own security checking. VHS relies on the
security system provided by Pathway to check for two authorization levels:
•
Who can install and start the VHS Browser facility
•
Who can run the VHS Browser facility
When INSTVHS is run, the VHS ISV files are restored with the operator’s ownership
and security values. Verify these values to ensure that they are acceptable. VHS
installation procedures require read access to the ISV files and result in files being
copied and created on the VHS-BROWSER-SUBVOL parameter subvolume.
Modifying the VHS Configuration Files
After you have installed the VHS process, VHSCI, VHS GUI Agent facility, and the
VHS Browser facility, you can modify the VHS configuration files (see Figure 2-5):
•
VHSSTART (VHS custom startup file)
•
VHSINSP (VHS Inspect file)
•
VHSCSTM (VHSCI custom configuration file)
•
VHSBCONF (VHS Browser environment configuration file)
•
VHSGCONF (VHS GUI Agent configuration file)
ZVHSCONF Starts the Pathway system.
ZPATHWAY Adds VHS servers to the Pathway configuration.
ZVHSSTRT Starts the VHS servers.