Virtual Hometerm Subsystem (VHS) Manual (H06.03+)

Installing VHS
Virtual Hometerm Subsystem (VHS) Manual—429311-001
2-37
VHS Parameters
VHS Parameters
Table 2-8 lists each parameter used by VHS and its default value if omitted.
Table 2-8. VHS Parameters (page 1 of 2)
Parameter Name Default Description
ACCEPT-EXT-
ASCII-
CHARACTER
OFF Specifies if VHS will accept non-ascii characters (e.g.
Kanji). The value can be ON or OFF.
AUTOMATIC-
INSPECT-
PROCESSING
ON Specifies if VHS will automatically process Inspect
prompts. The value can be ON or OFF.
BACKUP-
CREATION-DELAY
5 Delay in minutes between each occurrence of the backup
creation failure message. The value must be between 0
and 999.
ENVIRONMENT VHS Specifies the name of the environment that this VHS
process will run. This name has two purposes: a prefix for
all EMS messages generated, and for the VHS Browser
facility to specify which VHS environment the user wants
to look at.
GENERATE-
DISPLAY-EVENT
ON Specifies if EMS events must be generated for display
type messages. The value can be ON or OFF. If the VHS-
GUI-MODE parameter is ON, GENERATE-DISPLAY-
EVENT will always be considered to be ON.
GENERATE-
INSPECT-EVENT
ON Specifies if EMS events must be generated for
Inspect/Debug type messages. The value can be ON or
OFF. If the VHS-GUI-MODE parameter is ON,
GENERATE-INSPECT-EVENT will always be considered
to be ON.
GENERATE-
PROMPT-EVENT
ON Specifies if EMS events must be generated for
prompt/reply type messages. The value can be ON or
OFF. If the VHS-GUI-MODE parameter is ON,
GENERATE-PROMPT-EVENT will always be considered
to be ON.
MAXEXTENTS 16 Specifies the maximum number of extents to be created
for the primary log file. The value is an integer in the
range of 0 through 978.
OPEN-TABLE-
THRESHOLD
90 Specifies the percentage of full value of the opener table
at which VHS will generate an EMS event message. The
value must be between 0 and 100.
PRIMARY-
SECURITY
NUUU Specifies the default security used by VHS when it
creates primary log files.