Virtual Hometerm Subsystem (VHS) Manual (H06.03+)

Using VHS
Virtual Hometerm Subsystem (VHS) Manual—429311-001
3-8
Pathway Application Example 2
By default, each server class uses the home terminal of the PATHMON process.
Pathway Application Example 2
If you have already hardcoded the HOMETERM attribute for every server in the
Pathway configuration file, you will have to modify the HOMETERM attribute as
specified for the EMPLOYEE-SERVER in the following example. The command that
specifies VHS as the home terminal is in boldface.
Note. If you create your new Pathway configuration file by using the OBEYFORM facility,
then all TCPs and servers will have the SET HOMETERM parameter set. Check to make
sure all home terminals are set to the VHS process.
SET PATHMON BACKUPCPU 1
SET PATHWAY MAXASSIGNS 10
SET PATHWAY MAXDEFINES 5
SET PATHWAY MAXPARAMS 5
SET PATHWAY MAXPATHCOMS 5
SET PATHWAY MAXPROGRAMS 5
SET PATHWAY MAXSERVERCLASSES 5
SET PATHWAY MAXSERVERPROCESSES 20
SET PATHWAY MAXSTARTUPS 5
SET PATHWAY MAXTCPS 5
SET PATHWAY MAXTERMS 10
SET PATHWAY MAXLINKMONS 16
START PATHWAY COLD !
RESET TCP
SET TCP AUTORESTART 2
SET TCP MAXREPLY 2000
SET TCP MAXTERMDATA 32000
SET TCP SERVERPOOL 20000
SET TCP TERMPOOL 8000
SET TCP MAXTERMS 25
SET TCP MAXPATHWAYS 5
SET TCP PROGRAM $SYSTEM.SYSTEM.PATHTCP2
SET TCP TCLPROG POBJ
ADD TCP TCP-6530, CPUS 0:1
RESET PROGRAM
ADD PROGRAM EMPREQ, TYPE T16-6530 (INITIAL EMPREQ), TCP TCP-6530
RESET SERVER
SET SERVER PROGRAM EMPSRV
SET SERVER CPUS (0:1)
SET SERVER HOMETERM $VHS
SET SERVER MAXSERVERS 5, NUMSTATIC 0
SET SERVER LINKDEPTH 1, MAXLINKS 5
SET SERVER TMF ON, AUTORESTART 2
SET SERVER ASSIGN ERROR-LOG-FILE, ERRORLOG
SET SERVER ASSIGN EMPLOYEE-FILE, EMPLOYEE
ADD SERVER EMPLOYEE-SERVER
RESET SERVER
SET SERVER PROGRAM TSTSRV
SET SERVER CPUS (0:1)
SET SERVER MAXSERVERS 5, NUMSTATIC 0
SET SERVER LINKDEPTH 1, MAXLINKS 5
SET SERVER TMF ON, AUTORESTART 2
SET SERVER ASSIGN ERROR-LOG-FILE, ERRORLOG
SET SERVER ASSIGN EMPLOYEE-FILE, TESTCONV
ADD SERVER TESTCONV-SERVER