BackBox H4.00 User Manual

User Interface
121 BackBox H4.00 User Manual
In VTCs, all domains allowed to access the VTC must be registered in this list.
The Domain Address page allows the user to create, edit, or delete a domain address.
See more details in the Client UI Installation manual
.
Stand Alone Load
The Stand Alone Load is reserved for cases where the Domain Manager is not available
and a virtual volume must be loaded:
When a NonStop server is cold loaded from a SIT virtual tape.
When the Domain Manager is not operational because the BackPak catalog
(Guardian files VOLUME*) is not available.
The files VOLUME* might be backed up by BACKUP or TMF on virtual volumes.
The virtual volumes needed to restore the VOLUME* files must then be loaded
without the help of the Domain Manager through this Stand Alone Load.
Some restrictions apply:
The user must run the BackPak GUI in the VT Controller that emulates the tape
drive for the targeted NonStop server.
This is a low-level tool requiring the user to enter all configuration information:
the internal virtual drive address and details about the virtual volume storage
(ex: name of the disk files of a virtual volume in a Windows Data Store).
The volume will always be loaded in Read-Only mode.
Encrypted volumes cannot be used.
The page layout varies depending on the selected Data Store Type. Elements displayed
in the “Stand Alone Load” paragraph are common.