BackBox H4.00 User Manual

User Interface
174 BackBox H4.00 User Manual
The physical media capacity must be able to contain the whole virtual volume, check the
volume detail page, “Data size” item.
Page elements
Status: Link to a Status page that will show all virtualizations and
materializations on all VTCs that have configured physical/external tape drives.
Volume label: Volume label to export.
The Windows Tape Device section describes the target device for this operation:
VT Controller ID: Identifies the VT Controller that is equipped with a tape
device to write on, and that is a route for the Data Store attached to the Volume
Group.
Tape Device: Select a physical tape device attached to VT Controller ID
selected. The physical tape device needs to be declared into the VT Controller
Advanced configuration page prior to be used in materialization.
Compression: Check to enable the compression feature of the device, if
applicable.
Idle time out: Maximum time the VTC will wait for the media be loaded, before
ending the Materialization session.
Feed-back
The GUI will show this kind of message:
I3386 Materialization initiated in VTC TINTIN on device SDLT.
EMS will report the starting and the ending of the Materialization session, and
the processing of the volume to process.
15:55 \ETINIUM BPAK-TINTIN-I5110 Starting MATERIALIZE session on
tape device SDLT
15:56 \ETINIUM BPAK- TINTIN -I5050 Materializing virtual volume
BBC001 started successfully
15:57 \ETINIUM BPAK- TINTIN -I5046 Materializing virtual volume
BBC001 ended successfully
15:57 \ETINIUM BPAK-TINTIN-I5111 Ending MATERIALIZE session on tape
device SDLT