Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

About This Document
This manual provides overview information about the HP NonStopTM™ Cluster I/O Protocols (CIP)
subsystem as well as procedures for configuring, managing, and migrating to CIP.
Supported Release Version Updates (RVUs)
This manual supports J06.05 and H06.16 and subsequent J-series and H-series RVUs until otherwise
indicated in a replacement publication.
Intended Audience
This manual is intended for network and storage administrators who need procedures for installing
and managing the CIP subsystem on an HP Integrity NonStop system; system planners and other
decision makers can also use this manual to study the CIP product and the migration requirements
for using CIP.
New and Changed Information
New and Changed Information in the 541613-024 Edition
• In Chapter 1, updated “Using Multiple SWAN Paths in a Single Provider” with details about
configuration under “Using Multiple Providers” (page 34).
• In Chapter 3, corrected syntax in “Adding the Collector” under “Configuring Transport of
Authentication Events from CLIM” (page 108).
• In Chapter 3, updated “climbkup and climrstr Considerations” (page 115) with additional
information.
• In Chapter 4, updated “Estimating Time for CLIM Firmware Updates” (page 154) and
“Performing CLIM Firmware Updates with the System Running” (page 155) to clarify steps.
New and Changed information in the 541613-023 Edition
• Corrected Figure 12: DL380p Gen8 IP CLIM 1 Interfaces — Five Copper Ethernet Interfaces
(page 54).
• Updated climconfig.interface(1) with clearer syntax diagram.
Supported Release Version Updates (RVUs) 13