Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

> ABORT MON $ZZCIP.ZCMprocessor-number
Open connections still exist, okay to continue? Y
7. The CIPMON processes are restarted automatically. Check to make sure each one is up before
doing the next one.
8. Restart the measure subsystem.
Replace CIPMAN (Only)
TCP/IP socket connections are not lost during this procedure. Storage paths are also unaffected
by this procedure.
1. Rename the existing CIPMAN file by using the TACL command:
> RENAME $SYSTEM.SYSnn.CIPMAN, $SYSTEM.SYSnn.CIPMANx
2. Install the new CIPMAN as $SYSTEM.SYSnn.CIPMAN.
3. Stop the CIPMAN process by using the SCF command:
> ABORT PROCESS $ZZKRN.#ZZCIP
4. Restart the CIPMAN process by using the SCF command:
> START PROCESS $ZZKRN.#ZZCIP
Replace CIPMAN and CIPMON Simultaneously
This procedure is required if there is a requisite between the new CIPMAN (T0690) and CIPMON
(T0694) called out in the respective softdocs.
CAUTION: TCP/IP socket connections are lost during this procedure. Storage paths are unaffected
by this procedure.
1. Rename the existing CIPMON and library files by using the TACL commands:
> RENAME $SYSTEM.SYSnn.CIPMON, $SYSTEM.SYSnn.CIPMONx
> RENAME $SYSTEM.SYSnn.ZCIPDLL, $SYSTEM.SYSnn.ZCIPDLLx
> RENAME $SYSTEM.SYSnn.ZCIPMDLL, $SYSTEM.SYSnn.ZCIPMDLx
2. Rename the existing CIPMAN file by using the TACL command:
> RENAME $SYSTEM.SYSnn.CIPMAN, $SYSTEM.SYSnn.CIPMANx
3. Install the new CIPMON as $SYSTEM.SYSnn.CIPMON.
4. Install the new CIP library as $SYSTM.SYSnn.ZCIPDLL.
5. Install the new Measure interface to CIP as $SYSTM.SYSnn.ZCIPMDLL.
6. Install the new CIPMAN as $SYSTEM.SYSnn.CIPMAN.
7. Stop the Measure subsystem.
8. Abort the CIPMON processes on all CPUs (see CAUTION below):
> ABORT PROCESS $ZZKRN.CIPMON
9. Wait for the CIPMON processes to stop (approximately 15 to 30 seconds):
file $SYSTEM.SYSnn.CIPMONx is no longer Open.
10. Stop the CIPMAN process by using the SCF command:
> ABORT PROCESS $ZZKRN.#ZZCIP
11. Restart the CIPMAN process by using the SCF command:
> START PROCESS $ZZKRN.#ZZCIP
12. Restart the CIPMON processes by using the SCF command:
134 Upgrading CIP