Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

lun
Is a decimal LUN number.
If no lun is specified, deletes all enclosure table entries with no corresponding device LUNs.
Confirms with "Are you sure?".
Enclosures Command
Displays the enclosure table and enclosures present. The syntax is:
-e |
--enclosures
Example of Lunmgr Enclosures Command
Verify that the CLIM can see the corresponding ESS port WWN and that it is in the CLIM's enclosure
table with the lunmgr --enclosures command.
> CLIMCMD s1002532 lunmgr --enclosures
The system displays the enclosures. This example shows two ESS ports connected but not yet
approved into the enclosure table and one connected SAS disk enclosure that has been approved:
-- Enclosure table --
lun type stable address
100 1 enclosure 500110a000781200
-- Enclosures present --
dev type stable address controller serial # revision
sda 2 port 50060e8004289406 slot 1, port 1
sdw 2 port 50060e8004289416 slot 1, port 1
sg63 1 enclosure 500110a000781200 slot 3, port 1, expander 1 SGA7060029 2.10
Type 1 is a SAS disk enclosure. Type 2 is an ESS port. You can identify the port WWNs of the
ESS in the stable-address column.
Find Command
Finds the physical identity of a device LUN. If no LUN is specified, find all devices. This provides
additional information which is not shown by --print. The syntax is:
-f [lun] | --find [lun]
lun
Is a decimal LUN number.
If no lun is specified, find all devices.
Example of Lunmgr Find Command
To obtain the Storage CLIM's LUN for the SCF ADD DISK command:
> CLIMCMD s1002532 lunmgr --find
lunmgr displays the Storage CLIM's LUN:
lun type controller location
1012 2 (disk-ess) slot 1, port 1 port 50060e8004289406, lun 12 (0xc)
1513 2 (disk-ess) slot 1, port 1 port 50060e8004289416, lun 13 (0xd)
The LUN shown on the left (under lun) is the Storage CLIM's LUN that you use in the SCF ADD
DISK command. The port and LUN on the right (under location) are the ESS's port WWN and
LUN.
Help Command
Displays a list of valid lunmgr options and effects. The syntax is:
-h | --help
Led Command
Turns on or off an enclosure or disk locator LED. The syntax is:
Lunmgr Commands 171