Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

• Assigns new Storage CLIM LUN numbers to previously unknown storage devices.
• Recognizes the CLIM boot disk and excludes it from the LUN Table.
The syntax is:
-u [ verbose ]| --update [ verbose ]
Verbose
Displays the device table and devices present.
Considerations for the Update Command
Only 512 devices per CLIM are supported. If the device table is full, lunmgr displays this error
message on the screen and in the NonStop host system EMS log:
Can't add lun lun_number. 512 devices already in table.
The recovery is to make fewer than 512 devices visible to the CLIM. Contact your service provider
for this task.
WWNs Command
Displays the WWNs of all fibre channel HBA ports. The syntax is:
-w | --wwns
Lunmgr Commands 173