Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

◦ Added new man page, climconfig.iptables(1).
◦ Added new man page, climconfig.ip6tables(1).
• For the failover command, climconfig.failover(1), updated error message to read: “Invalid
destination interface, it should be one of the eth[1-n], bond[0-n] or ib[0-n].”
• For the interface command, climconfig.interface(1), updated the -mtu parameter and error
messages to indicate no support for InfiniBand.
• For the sp command, climconfig.sp(1), added consideration for sp –add stating: “The
parameters protocol, mode and level are required and valid if and only if the parameter
specified for policy is ipsec.”
TCPTIMEWAIT Parameter
For the TCPTIMEWAIT parameter:
• Added text to TCPTIMEWAIT in the table under “NonStop TCP/IPv6 Attributes and Their CIP
Equivalents” (page 194).
• Added text to the “TCPTIMEWAIT” (page 198) subsection.
Src Parameter
-src option updates include:
• Added new error message to climconfig.ip(1).
• For climconfig.route(1), made these changes:
Updated the syntax for the default and non-default IPv4 routes.◦
◦ Added the -src parameter and its description.
◦ Added a column for the -src parameter to the table that shows possible option
combinations for different route types.
◦ Added new error messages.
◦ Added the consideration, “-src is not valid for an IPv6 route.”
◦ Added Src to the examples.
• For the interface command, added Src to “EXAMPLES” (page 319).
Obeyform Parameter
Obeyform updates include:
• Added new climconfig.all(1) reference page.
• Updated climconfig.arp(1).
• Updated climconfig.bondmode(1).
• Updated climconfig.climiptables(1).
• Updated climconfig.failover(1).
• Updated climconfig.interface(1).
• Updated climconfig.psk(1).
• Updated climconfig.remote(1).
• Updated climconfig.route(1).
• Updated climconfig.sa(1).
20