Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

• Updated climconfig.snmp(1).
• Updated climconfig.sp(1).
• Updated climconfig.sysctl(1).
• Updated climconfig.tunnel(1).
CLIM-to-CLIM Replication
Replicate CLIM-to-CLIM updates include:
• Added new subsection to Chapter 3: “Replicating the Configurations from One CLIM to Another
CLIM” (page 99).
OSM Down System CLIM Firmware Update Tool
OSM Down System CLIM Firmware Update Tool updates include:
• Rewrote and rearranged text concerning software and firmware updates in Chapter 4.
Other Changes
• Added link to “Upgrading IB and Telco CLIMs” to list under “Upgrading CLIM Software and
Firmware” (page 135).
• Under “Collecting CLIM Log Files using CLIMDBUG” (page 206), added additional information
that CLIMDBUG.
Changes to 541613–018 include:
• Added support to InfiniBand CLIM: “CIP Hardware Overview” (page 27), “IB CLIM” (page 56),
and “Upgrading IB and Telco CLIMs” (page 145).
• Added a section on “Mapping CLIM Name” (page 128) under Troubleshooting.
• Added a chapter “Collecting Data for CLIM Issues” (page 206).
• Updated Table 4: CLIM and Attached Storage Device Default Naming Conventions (page 62)
for IB CLIM naming conventions.
• Updated the manpages for climconfig.remote(1) command, climconfig.interface(1),
“climconfig.ip Description” (page 321), and climconfig.route(1).
• Updated Considerations section of the climconfig.sysctl(1) command.
• Added a note to “Upgrading CLIM Software and Firmware” (page 135) describing a shorter
procedure that can be used if you are not performing a SUT update.
Changes to 541613–017 include:
• A correction was made to the ordered list on (page 118). The former step 2, stopping the
CLIMs, is now step 4, after stopping the Providers.
• Reorganization of the CLIM software and firmware update procedures for use on an active
system, including the addition of two notes to the CLIM firmware update section.
• The addition of CLIM software and firmware update procedures optimized for use when the
system is down or idle.
Changes to 541613-016 include:
• Updated the Table 5: Sample Safe Linux Commands (page 69) with detail description for
Linux commands.
• Updated the Example 69: STATUS CLIM Detailed (page 258), Example 77: STATUS PROVIDER
Detail (page 268), and Example 98: INFO SUBNET (CIPSAM) (page 285) with the additional
loopback address information.
New and Changed Information 21