Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

9 Telco CIP Migration, Compatibility and Operational
Differences
There are operational differences between configuring the 6763 Common Communication ServerNet
Adapter and CLIMs systems. This chapter describes those differences. The two biggest differences
are the introduction of a new I/O subsystem (CIP) for CLIM configuration and the absence of the
SLSA subsystem.
NOTE: The Telco CLIM is not a replacement for the CCSA because it does not provide E1/T1
support.
Table 23: IOAM and Telco CLIM Based Operations Comparison shows comparison between tools
and tasks on IOAM and CLIM based operations:
Table 23 IOAM and Telco CLIM Based Operations Comparison
CLIM Based OperationsIOAM Based OperationsTool/Task
Telco CLIM6763 CCSACommunication device
SCF for CIP subsystem and CIP
subsystem CLIMCMD command line
interface (CLI)
SCF for the SLSA subsystemManagement interface
SCF command ADD CLIM
$ZZCIP.CLIM-name
SCF command ADD ADAPTER
$ZZLAN.adapter-name
Add a Telco communication device
No equivalentSCF command ADD LIF
$ZZLAN.lif-name
Add a logical interface to a device
SCF command START CLIM
$ZZCIP.CLIM-name
SCF command START ADAPTER
$ZZLAN.adapter-name
Start a Telco communication device
SCF command STATUS CLIM
$ZZCIP.CLIM-name or INFO CLIM
$ZZCIP.CLIM-name
SCF command STATUS ADAPTER
$ZZLAN.adapter-name or INFO
ADAPTER $ZZLAN.adapter-name
Obtain information about a Telco
communication device
SCF command VERSION CLIM
$ZZCIP.CLIM-name
No equivalentObtain version information about
software on a Telco communication
device
215